Your coupon for will be reflected when you check out!
✖
Your coupon for
✖
Hello!
You're visiting the PartSelect site in U.S.
Would you like to shop on the Canadian site?
Stay on this site
Go to Canadian site
✖
Model Number Locations
1Select Category Type
Select Category Type
2Select Product Type
Select Product Type
3Select {MODEL} Type
Select {MODEL} Type
Sample Model Number Tags
Model numbers can be made up of numbers (1005400, for example) or a combination of letters and numbers (LAT1000AAE). The model number will most likely appear on either a paper sticker or a metal plate. Your appliance's model number tag may look similar to the sample model number tags shown here (model number highlighted in yellow):
Model has been saved to My Models. If you're not signed in, your lists are available on this device and will expire within 30 days.
Model has been saved to My Models.
This OEM replacement part is used to pump fuel from the tank to the carburetor in order to start the engine. It may also be referred to as a Primer Bulb. It is made of durable black plastic and is sol...
This is a genuine replacement part sourced directly from the manufacturer. The throttle wire is found in chainsaws from Tanaka and Hitachi. This is a metal cable with flexible plastic casing, used t...
This is a genuine manufacturer-sourced component which is specially made for Tanaka and Hitachi chainsaws. It is an identical replacement for a missing or a faulty Guide Plate-B that was installed on ...
This part is available as an individual replacement. The metering diaphragm goes between the diaphragm gasket and the diaphragm cover. During replacement, it may require a screwdriver to help install ...
This is a genuine part which is supplied directly by the original equipment manufacturer and is used with Tanka and Hitachi chainsaws. The air filter cleans the air entering and exiting the carburetor...
This genuine manufacturer sourced replacement component which is specially designed for use with Tanaka and Hitachi handheld lawn and garden equipment. It helps to distribute the pressure evenly betwe...
This is an original Tanaka replacement part. The bar clamp nut is designed by the manufacturer for use in chainsaws, pruning saws, and hedge trimmers. This part is made of metal, and may be found in...
Ask our experts a question about this model and we'll get back to you as soon as possible!
1 question answered by our experts.
Sort by:
< Prev
1
Next >
Search filter:
Clear Filter
Your search term must have 3 or more characters.
Keep searches simple. Use keywords, e.g. "leaking", "pump", "broken" or "fit".
Sorry, we couldn't find any existing answers that matched.Try using some different or simpler keywords, or submit your new question by using the "Ask a Question" button above!
Ramon
March 29, 2023
How do you replace this part on my Hitachi chain saw,Mod#CS33ET and are any special tools or parts required?Part#6685144
For model number CS33ET
Hello Ramon, Thank you for your inquiry. We have included a link below to our general repair video on removing the clutch from a chain saw, which also explains how to remove the clutch housing/drum, which is part# 6685144 for your model. You should only need a nut driver to remove the screws. Good luck with your repair. https://www.youtube.com/watch?v=aAtqBtAbmGE
Did this question help you?
Thank you for voting!
< Prev
1
Next >
✖
Ask a Question
Ask our experts a question on this model and we'll respond as soon as we can.
The unit is a press fit. To remove the old one required breaking the plastic compression tabs that hold it in place. That was simple enough. Replacing requires lining up in the correct position to meet the inner hose. Then push it in. The compression tabs on the replacement click in and hold.in place.
