CS-300EVL Echo Chainsaw - Overview

This is a genuine OEM replacement part, it is sold individually. It is used in various places on the models shown below.. It is mainly use to secure parts such as Guide Bar Covers, Sprocket Guards etc.

This replacement tensioner is specially designed for use with Echo pole pruners/chainsaws. This part is a crucial component of chain tensioning mechanism. If the bar doesn't adjust when you turn the tension screw usually the tensioner pin or the adjustment bolt is worn or damaged. This part is made out of metal and it is sold individually.

This spark plug wire, also known as a spark plug coil or spark plug cap coil, is compatible with various makes and models of hand-held outdoor power equipment and is sold individually. This wire is installed within the spark plug boot and attaches to the spark plug for the ignition of your equipment. The spark plug wire is often exposed t...Read moreo extreme heat and excessive vibrations, so through normal wear and tear, it will likely break down. If your equipment is having difficulty starting or has general performance issues, the wire may be the reason why. To replace this wire, make sure your equipment is off before removing the wire and boot from the spark plug. Remove the boot from the wire and install the new wire within the boot before re-installing the boot back to the spark plug.

This plastic clip is an OEM part direct from the Echo manufacturer. This part is compatible with many chainsaw devices. The clip is secured onto the adjustment screw, and helps to work as a grip for the screw. Please refer to specific instruction manual for repair instructions. This part is sold individually. A screwdriver and a wrench are often needed to make the proper removal and replacement.

This is an authentic manufacturer sourced replacement part designed for use with Echo backpack blowers. This carburetor gasket provides an air tight seal between the carburetor and the insulator. Over time gaskets tend to deteriorate and would need to be replaced. It is made out of compound material and it is sold individually. You would need a screwdriver to replace this item.

This OEM metal washer is commonly used on a variety of different small engine/lawn equipment models and is sold individually. This washer is used to help evenly distribute pressure from the securing bolt or screw with the cylinder cover, to reduce any effects of vibration from the engine. If the connection between the securing fastener be...Read morecomes loose, or if you are replacing the fastener itself, it is recommended that you replace this washer as well.

This replacement spark plug cap is a genuine OEM sourced item designed for use on handheld lawn and garden equipment. It is used to insulate the plug and wire terminal. Over time rubber material can dry out and crack requiring replacement. Please note, this item is sold individually.

This replacement part is an authentic OEM screw designed for use with blowers and string trimmers. This is a standard hardware which has multiple uses based on equipment. Please refer to diagrams for proper application. This screw is made out of metal and it is sold individually. To secure or loosen this screw you would need a phillips head screwdriver.

This is a simple adhesive sticker/decal with Echo logo. It is commonly used on handheld lawn and garden equipment such as trimmers and blowers. Please make sure to check appropriate diagrams of your model to check the location for this label. It is an authentic manufacturer approved replacement item which is sold individually.

Made specifically for repairs done on handheld lawn and garden equipment, this OEM wrench is silver and made of durable metal. It is sold individually. This wrench is sourced directly from the manufacturer and should be replaced once it becomes damaged or worn.

This is an original Echo replacement part manufactured for use with outdoor power equipment. This special screw includes a washer and can be used with either flat or phillips head drivers. The screw has different applications, please see model diagram for part location and use. The screw is sold individually.

It is a genuine OEM approved replacement item specially designed for use with Echo gas powered handheld tools. This replacement fuel-strainer/filter fits inside of the fuel tank. The purpose of this item is to filter out dirt and debris from contaminating engines. Over time fuel filter will get clogged and restrict the fuel getting to the...Read more carburetor. At this point filter should be replaced. This filter consists of a metal body with fabric filter material and it is sold individually.