Models > CRT182HNB5 > Instructions

CRT182HNB5 Crosley Refrigerator - Instructions

All Instructions for the CRT182HNB5
1 - 15 of 194
Keep searches simple. Use keywords, e.g. "leaking", "pump", "broken" or "fit".
Refrigerator would not run but interior light was on.
I unplugged the refrigerator, then opened the door and removed four screws holding the plastic electrical panel to the interior top of the main refrigerator compartment and noticed the cold control was corroded badly, apparently from moisture in the panel. I ordered a new one from partselect.com. When it arrived the next day, I then pulled off the control knob, unclipped the cold control, unplugged the three wires to the control, then removed the styrofoam insulation blocks holding the thermocouple wire and then removed the thermocouple wire to complete the removal. I then reversed the process to install the new thermostat and control. That is repositioned the thermocouple wire, put the insulation blocks back to hold the wire, then replugged the three electrical wires, clipped the control back and pushed the control knob back on and finally screwed the panel back to the top of the main compartment and plugged the refrigerator electrical cord back in to provide current to the refrigerator. It immediately started up and ran fine. Total time - about 8 minutes.
Parts Used:
Cold Control Thermostat
  • Bruce from Alton, IL
  • Difficulty Level:
    Really Easy
  • Total Repair Time:
    Less than 15 mins
  • Tools:
    Pliers, Screw drivers
178 of 231 people found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
door rack was broken
pulled broke rack off, snapped new one in place. Yeah!! No more broken jars on the floor.
Parts Used:
Door Shelf Retainer Bar
  • Lannie from Buffalo, WY
  • Difficulty Level:
    Really Easy
  • Total Repair Time:
    Less than 15 mins
72 of 91 people found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
The retainer door shelf broke 3 years ago
I just snapped the new shelves in place and !voila! I should've done this years ago.
Parts Used:
Door Shelf Retainer Bar
  • Cynthia from Long Beach, CA
  • Difficulty Level:
    Really Easy
  • Total Repair Time:
    Less than 15 mins
63 of 83 people found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
The Crisper Drawer Glass Shelf slid out of the frame while being cleaned and shattered.
The repair didn't require any tools at all. Just simply slide the new glass shelf carefully into the the frame and while holding it horizontally slide the frame back into the rails. This took less than a minute to accomplish. Very satisfied with the results.
Parts Used:
Crisper Glass Shelf Insert
  • Ernesto from Porter, TX
  • Difficulty Level:
    Really Easy
  • Total Repair Time:
    Less than 15 mins
42 of 52 people found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
Glass shattered
Don't ever tell your 11 year old to clean the refridgerator. Something will almost definetly get broken like the glass shelf, but luckily I had parts select which in no time assisted me to find the exact part. I ordered the part, it came quickly and I replaced within seconds.
Thanks.
Parts Used:
Crisper Glass Shelf Insert
  • Adona from Gretna, LA
  • Difficulty Level:
    Really Easy
  • Total Repair Time:
    Less than 15 mins
28 of 33 people found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
Kids Broke The Retaining Bar On The Frige.
Simply snap the old ones out and install the new ones. Piece of cake. . . . . And saved some $$$.
Parts Used:
Door Shelf Retainer Bar Door Shelf Retainer Bar
  • John from Eden, NY
  • Difficulty Level:
    Really Easy
  • Total Repair Time:
    Less than 15 mins
24 of 26 people found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
Refrigerator not cooling, Freezer working fine
Frig area was at about 50 degrees and would not get cooler. Freezer was working great.
Empty the freezer and remove the two screws that hold the back panel of the inside of the freezer on. Pull the panel out and you will see the fan that is mounted to the back of the panel. If the fan is not running, disconnect it (quick connector) and check to see if there is voltage coming to it from the connector (should be 120VAC between the two wires). If there is power, and the fan was not working, replace the fan.

Fan just snaps into the holder on the back panel and plugs into the quick connector. Make sure you clear any ice build-up in the hole between the freezer and the frig that the fans blows through. Put it back together and verify the fan runs.
Parts Used:
Evaporator Fan Motor
  • Roger from TRURO, IA
  • Difficulty Level:
    Easy
  • Total Repair Time:
    15 - 30 mins
  • Tools:
    Nutdriver, Screw drivers
21 of 23 people found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
Light Socket short
- Unsnapped old light socket from top of Frig
- Disconnected elect wires
- Reconnected elect wires to new light socket
- Snapped new socket in place
- Done in less than 2 min.
Parts Used:
Light Socket
  • Rebecca from Gautier, MS
  • Difficulty Level:
    Really Easy
  • Total Repair Time:
    Less than 15 mins
22 of 31 people found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
No freezer shelf came with our new refrigerator.
No long shelf came with our new refrigerator, Frigdaire did not have one so I went on-line from you and it fit perfectly, now everything does not have to be in one big heap.
Parts Used:
Freezer Shelf
  • TRACY from MAPLE GROVE, MN
  • Difficulty Level:
    Really Easy
  • Total Repair Time:
    Less than 15 mins
19 of 23 people found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
the glass shelf shattered
I placed the glass into the shelf frame and then I put the shelf and frame back into the refrigerator.
Parts Used:
Shelf Glass Insert - Glass ONLY
  • Steven from Merrick, NY
  • Difficulty Level:
    Really Easy
  • Total Repair Time:
    Less than 15 mins
25 of 44 people found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
rack door broke in half
Rack door slid into place easily. Repair required no tools and took maybe 20 seconds to install!
Very easy job!
Parts Used:
Door Shelf Retainer Bar
  • Lisa from Milwaukee, WI
  • Difficulty Level:
    Really Easy
  • Total Repair Time:
    Less than 15 mins
15 of 18 people found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
cracked bottom hinge
My 4 year old grandson used the frig door as a swing.The bottom hinge cracked, then the door wouldn't seal. I propped the door up with some books, removed the broken hinge (2 bolts) and replaced with the new part. Simple fix on the door, only time will fix the 4 year old!
Parts Used:
Lower Hinge Bracket
  • LEE from LEO, IN
  • Difficulty Level:
    Really Easy
  • Total Repair Time:
    Less than 15 mins
  • Tools:
    Socket set
14 of 18 people found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
Parts of the interior of the refrigerator were broken
All I did was take the old pieces out of the refrigerator, clean the glass and put in the new pieces. It was a simple solution and now my refrigerator is like new! AND, I didn't have to pay my appliance store for their repairman!
Parts Used:
Crisper Cover Frame - No Glass Front Shelf Trim
  • Lois from Marathon, FL
  • Difficulty Level:
    Really Easy
  • Total Repair Time:
    Less than 15 mins
14 of 20 people found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
Plastic fan broke
took the cover off
(cardbord) the fan will come off and go back on by hand no tools needed i changed the fan motor just to be sure. 3 little screws hold it on. the plug only goes on one way u can't mess it up.very easy job u shouldn't have any problems doing it.Jim
Parts Used:
Condenser Fan Motor BLADE-CONDENSER FAN
  • James from GLEN FLORA, TX
  • Difficulty Level:
    Really Easy
  • Total Repair Time:
    15 - 30 mins
  • Tools:
    Socket set, Wrench set
12 of 15 people found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
Crisper Pan
Just removed the broken pan and installed the new one within 2 minutes. Really simple
Parts Used:
Refrigerator Crisper Pan
  • Deepankar from Novi, MI
  • Difficulty Level:
    Really Easy
  • Total Repair Time:
    Less than 15 mins
13 of 20 people found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
All Instructions for the CRT182HNB5
1 - 15 of 194