CLS33T ((24BL59M5897)(2016)) MTD Log Splitter - Overview

Bow Tie Cotter Pin Sourced directly from the manufacturer, this replacement part is designed to secure otherwise loose parts in place, allowing the machine to operate properly. This Bow Tie Cotter Pin is not part of a k... Add to cart

Nut, Flange Lock, 5/16-18, Grf This nut is a manufacturer-approved replacement part for various lawn and garden equipment. It is sold individually, not as part of a kit or assembly. Also referred to as a Lock Nut, it is resistant t... Add to cart

Self-Tapping Screw, 5/16-18, .750 Add to cart

Nut, Flange Lock, 3/8-16, Grf Designed for use in various models of lawn and garden equipment, this part is not sold as part of a kit or assembly. It is made of metal, is gold in color, and is sold individually. This part may also... Add to cart

Spider Bushing This rubber and plastic spider bushing is a genuine OEM part for various makes of log splitters and is sold as an individual part. Measuring at approximately 2-inches by 2-inches, this bushing is atta... Add to cart

Plastic Bushing .380 ID This is an authentic OEM part for Craftsman lawn and garden equipment. This bushing has an internal diameter of 0.380", is made of durable black plastic, is not part of an assembly or kit, and is sold... Add to cart

Washer-Lock 5/16 This Washer-Lock 5/16 is a silver, metal part that is sold individually and comes direct from the manufacturer. With a 5/16 Inch Interior Diameter and 1/2 Inch Outside Diameter, it is used to prevent ... Add to cart

Filter Housing

★★★★★

★★★★★

(1)

Add to cart

Coupling, .500 This coupler connects the engine or motor to the hydraulic pump in your lawn equipment. It has a 0.5-inch inside diameter and is typically located near the rear coupling support bracket. If the couple... Add to cart

Push Cap The Push Cap is a black plastic cap which secures to the end of a shaft to prevent injury. It can be installed with a hammer and is rated as "Easy" to install. If the part appears damaged or worn down... Add to cart

Back Plate This back plate, also known as a wedge plate, is sourced directly from the manufacturer for use in log splitters. It is a flat, metal plate found at the rear end of the machine, with a length of 8 inc... Add to cart

Hub Cap This OEM Hub Cap, or Dust Cap, is a 2-inch, silver, steel part, sold individually. It requires a Rubber Mallet to install and its installation is rated as Easy by our customers. This part attaches i... Add to cart