CG206B-E Jenn-Air Cooktop - Overview

This is a surface burner knob. This knob is a little under 2 inches in diameter. It is a black part with gray numbering indicating the temperature level of the surface burner: low, medium, high, off, and lite. This knob is made entirely of plastic. Its function is to allow the user to control the heat coming from the surface burner on the...Read more range. This model will only accept a D-shaped shaft. To make this repair, grab the knob with a tight grip and pull it straight off the shaft. When you receive your new part, you can snap it back into place.

The function of the grease filter is to trap grease into the filter from the exhaust air. The grease filter is intended to be used with certain downdraft cooktops and ranges. This grease filter is roughly fourteen inches long and almost twelve inches wide, and chrome in color. Removing your old grease filter and replacing it with a new on...Read moree is an easy job, users say it took them less than fifteen minutes to install. We recommend that when removing your current grease filter, you use work gloves to protect your hands and clean the entire area thoroughly before installing the new filter.

This is a multi-use and multi-appliance screw. It can be used on a microwave, refrigerator, range/oven, air conditioner, dehumidifier, washer, or dryer. The measurements of this screw are 8 x 1/2 inch. It has 6 threads. Refer to the manual provided by the manufacturer for further information on repair and accurate guidance. Remember to wear work gloves as a safety precaution.

This screw is sold individually.

The hinges control the rate that the oven door opens and closes, and allows the door to stay open at an angle. This hinge can be used on either the left or right hand side of your oven, and is approximately 20 1/2 inches long. If your oven door will not open or close easily, you may need to replace this part. It may be a good idea to repl...Read moreace both hinges at the same time. If a spring has become loose on one hinge, the other hinge is likely to have the same issue. The repair is simple and only requires a Phillips screwdriver and a small bent nail. For a full step-by-step guide, check out the video below.

This black front burner assembly is a precision-engineered component designed for use with select gas ranges. Measuring nine inches in diameter, it provides reliable and consistent heat distribution for optimal cooking performance. Its durable construction ensures long-term functionality, while its seamless integration into the appliance ...Read moresupports safe and efficient operation. Installation involves positioning the burner securely in place on the cooktop, and it is recommended to verify compatibility with your specific model before installation.

This pan sits under the burner to catch anything that may spill over to make cleaning up easy. Also known as Aeration Pan. Sold individually.

This rear burner assembly directs gas to the burner head for even heat distribution. Finished in glossy black, it replaces worn or faulty parts that cause ignition or heating issues. Installation requires disconnecting the appliance and securing the new burner in place.

This burner grate kit contains two burner grates. Each grate in this kit is black and ten inches long.

This down-draft fan switch kit comes with the switch itself and two metallic push nuts. At 125 volts,this switch will allow for 6 amps, and at 250 volts, this switch will allow for 250 volts. This switch runs at 1/4 horsepower.

This jar is a little over five inches long. It is made of glass and is used for collecting the grease drippings of gas ranges.

This spark igniter electrode has a 35" wire lead.