This is a charcoal filter but you may know it as the vent hood filter. It is designed to work in multiple appliances. The purpose of the vent hood filter is to collect the grease particles and other tiny debris from the air while cooking. Take note that this part is sold individually. This charcoal filter is almost 12 inches long, and jus...Read moret over 6 inches wide. For safety purposes when making this repair, we recommend disconnecting the power to your appliance before changing the filter.
See how others fixed this model. Time, tools, difficulty, and steps that lead to victory!View More
Search repair tips from other customers using simple keywords like "replace", "fit", "remove", "inspect". DIY doesn't mean you have to do it alone!
Search filter:
Clear Filter
Your search term must have 3 or more characters.
Replace Charcoal Filter
33 of 49 peoplefound this instruction helpful.
Stuart from North Port, NY
Easy
Less than 15 mins
Screw drivers
Philips head screwdriver to remove 2 screws holding plastic grill above microwave door in place. Old Filter lifts out slide new filter in. It rests on an angle. Re insert Grill (careful that plastic tabs slide into proper slots). Tighten SCrews
Was this helpful?
Thank you for voting!
Microwave door window seal damaged.
10 of 11 peoplefound this instruction helpful.
Freddie from Roanoke, VA
Easy
30 - 60 mins
Screw drivers
The "seal" is a clear plastic sheet that forms the inner most layer of the "window" in the microwave door. If it becomes damaged or doesn't adhere properly, steam and other cooking by-products get inside the door itself. That's what happened in my case. As a result, I had to disassemble the entire door to clean the inside of the glass
... Read moreand other parts. If that cleaning had not been necessary, I could have replaced the seal without disassemblying the door.
To replace the seal, I followed these steps: 1. Used my thumb nail to raise a corner of the old seal. 2. Peeled off the old seal. This leaves a perforated metal layer exposed. 3. Cleaned the metal layer to remove residual adhesive from the old seal. 4. Once the metal layer was dry, my wife and I worked together to peel off the "backing sheet" from the new seal. (One side of the seal has adhesive on it - like the sticky side of tape. After you peal the backing off, the sticky side is exposed.) 5. After we CAREFULLY aligned the seal, I held it while my wife slowly and carefully pressed it into place.
Problems to watch out for: The seal is shipped "folded". This causes a crease to form in the plastic seal, which makes it difficult, if not impossible to install it without leaving any raised places. Note that raised areas in the center probably just look bad. But, raised areas around the edge may prevent a proper "seal" and result in steam, etc., getting inside the microwave door. I receved two separate seals and both had a crease. PartSelect reps were very nice, but were not able to correct the problem.
Read less
Was this helpful?
Thank you for voting!
Replace the bulb
16 of 29 peoplefound this instruction helpful.
Gary from McDonough, GA
Really Easy
Less than 15 mins
Screw drivers
Unscrew the glass lamp cover and replace the bulb. Very simple. The hardest part was to find the bulb. I looked at my local hardware stores but of course they did not have them. This site was great and easy to order. I looked at 3 other sites before finding this one to be the most simplistic to use.