The tools you will need to replace the surface burner receptacle kit on your range include a Phillips screw driver, and a pair of wire strippers. Before doing this repair, make sure to disconnect your appliance from the power supply and wear work gloves to protect your hands. The surface burner receptacle kit comes with a plastic block, h...Read moreigh temperature wire nuts, a metal bracket, and wires. This part functions as the connection between the wire harness and the surface element in your range.
This is a multi-use and multi-appliance screw. It can be used on a microwave, refrigerator, range/oven, air conditioner, dehumidifier, washer, or dryer. The measurements of this screw are 8 x 1/2 inch. It has 6 threads. Refer to the manual provided by the manufacturer for further information on repair and accurate guidance. Remember to wear work gloves as a safety precaution.
This eight inch delta frame surface burner element has five turns. It comes with one black and one chrome center medallion. This element is used with electric ranges.
See how others fixed this model. Time, tools, difficulty, and steps that lead to victory!View More
Search repair tips from other customers using simple keywords like "replace", "fit", "remove", "inspect". DIY doesn't mean you have to do it alone!
Search filter:
Clear Filter
Your search term must have 3 or more characters.
Stove top element not working due to bad receptacle.
196 of 216 peoplefound this instruction helpful.
Richard from Carthage, NC
Really Easy
Less than 15 mins
Pliers, Screw drivers
Turned off the power at the breaker box, cut the wires approximately 5 inches from the bad receptacle and removed it after removing one screw. Stripped back the wires about 1/2 inch and attached the new wires with the ceramic wire nuts provided and secured the receptacle back in place with the new screw provided in the kit. My sister
... Read more's husband wanted to scrap the whole range but I repaired it with $14.00 worth of parts. The element is working great now. Whenever I need appliance parts again I'll use partselect.com.
Read less
Was this helpful?
Thank you for voting!
The Burner was getting too hot and you could not regular the tempature
77 of 89 peoplefound this instruction helpful.
Dennis from Hagerstown, MD
Really Easy
Less than 15 mins
Screw drivers
Moved the Appliance out unplugged it and removed the backing plate then Remove the Knob and unscrew the infinite switch then marking the 5 wires to know where the go on the new switch, removing and replaced it with the new one
Was this helpful?
Thank you for voting!
could not control burner temp.
24 of 28 peoplefound this instruction helpful.
James from Chesapeake, VA
Really Easy
15 - 30 mins
Screw drivers
removed back cover removed wires removed two screws and removed switch replaced switch and two screws replaced wires and back cover