Models > CEB1590SS1SS

CEB1590SS1SS General Electric Microwave - Overview

Sections of the CEB1590SS1SS

[Viewing 6 of 6]

Manuals & Care Guides for CEB1590SS1SS

Click to download
Keep searches simple, eg. "belt" or "pump".
FUSE – Part Number: WB27X10928
FUSE
★★★★★
★★★★★
(19)
PartSelect #: PS1481237
Manufacturer #: WB27X10928
This ceramic microwave fuse is just over an inch in length. It is white in the center, and metal on both ends. This is a 20-amp fuse, and is used to power your microwave. If the touch pad on the micro...
$14.74
  In Stock
Glass Cooking Tray – Part Number: WB49X10129
Glass Cooking Tray
★★★★★
★★★★★
(25)
PartSelect #: PS956214
Manufacturer #: WB49X10129
There are two different couplers (also known as a turntable shaft) that can be used for this tray - a male D-shaped shaft and a female D-shaped shaft. The couplers are sold separately.
$106.12
  In Stock
Primary Door Interlock Switch – Part Number: WB24X10047
Primary Door Interlock Switch
★★★★★
★★★★★
(18)
PartSelect #: PS237015
Manufacturer #: WB24X10047
This interlock switch is located in the door latch.
$33.43
  In Stock
Oven Lamp – Part Number: WB36X10131
Oven Lamp
★★★★★
★★★★★
(14)
PartSelect #: PS247334
Manufacturer #: WB36X10131
This is a replacement oven lamp for your microwave. The base is made of black plastic, and the lamp itself is made of glass. The base is approximately 2 inches long and 1 inch wide. The bulb is locate...
$27.90
  In Stock
SWITCH MONITOR INTERLOCK – Part Number: WB24X25397
SWITCH MONITOR INTERLOCK
★★★★★
★★★★★
(4)
PartSelect #: PS11766871
Manufacturer #: WB24X25397
This is the replacement monitor switch for your microwave. It is black in color and measures approximately 1 inch by ¾ of an inch. This switch monitors the door latch position of your microwave and co...
$23.17
  In Stock
Turntable Guide With Rollers – Part Number: WB02X10719
Turntable Guide With Rollers
★★★★★
★★★★★
(7)
PartSelect #: PS223995
Manufacturer #: WB02X10719
This roller guide sits underneath the glass turntable tray.
$44.47
  In Stock
Microwave Magnetron – Part Number: WB26X32629
Microwave Magnetron
★★★★★
★★★★★
(5)
PartSelect #: PS12722595
Manufacturer #: WB26X32629
Genuine OEM magnetron for your microwave. Always use proper safety equipment and follow the manufacturers instructions while installing.
$188.98
  In Stock
Diode Cable – Part Number: WB27X10037
Diode Cable
★★★★★
★★★★★
(3)
PartSelect #: PS239148
Manufacturer #: WB27X10037
$26.53
  In Stock
THERMOSTAT – Part Number: WB21X10148
THERMOSTAT
PartSelect #: PS2321365
Manufacturer #: WB21X10148
This part will trip once the inside of the cavity overheats and exceeds the recommended temperature.
$23.46
  In Stock
Turntable Coupler – Part Number: WB06X10564
Turntable Coupler
★★★★★
★★★★★
(1)
PartSelect #: PS952386
Manufacturer #: WB06X10564
$11.91
  In Stock
WAVE GUIDE – Part Number: WB06X10254
WAVE GUIDE
★★★★★
★★★★★
(1)
PartSelect #: PS227965
Manufacturer #: WB06X10254
$14.39
  In Stock
CAPACITOR HIGH VOLTAGE – Part Number: WB27X11033
CAPACITOR HIGH VOLTAGE
PartSelect #: PS2353613
Manufacturer #: WB27X11033
$45.99
  In Stock

Questions And Answers for CEB1590SS1SS

Be the first to ask our experts a question about this model!

Common Symptoms of the CEB1590SS1SS

[Viewing 5 of 5]
No heat
Fixed by
these parts
Show All
Won’t turn on
Fixed by
these parts
Show All
Touchpad does not respond
Fixed by
these parts
Show All
Doesn’t shut off
Fixed by
these parts
Show All
Tray won’t turn
Fixed by
these parts
Show All
Keep searches simple. Use keywords, e.g. "leaking", "pump", "broken" or "fit".
Microwave completely stopped working
Turned out the issue was easily solved by replacing a single, inexpensive fuse.

First off, UNPLUG THE MICROWAVE.

The fuse is located under the plastic grill at the top of the microwave. It's held on by two screws. Once you've removed the screws and taken off the plastic grill, you go to the right side of the microwave and remove another screw that holds a small metal grill in place. Removing the small metal grill is probably the toughest part of this repair. You kind of have to rock it back and forth a bit to get it to release. Once that's off, you can get to the fuse. I removed the burnt out one with a pair of needle nose pliers. I also put a small piece of cardboard under the fuse when I did this so I didn't accidentally drop it into the innards of the microwave. I did the same thing when I replaced the new fuse. I then plugged the appliance back in and made sure it worked. Once that was confirmed, I replaced both grills.
Parts Used:
FUSE
  • Kim from Cliffside Park, NJ
  • Difficulty Level:
    Really Easy
  • Total Repair Time:
    15 - 30 mins
  • Tools:
    Screw drivers
904 of 1162 people found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
Bulb Replacement
Remove shroud . Two black philips head screws on side, and several on the back side. The two bottom screws on the back are special screws that a philips,straight slot, or hex screwdriver will not remove. I took a dremel tool with a thin metal grinding disc and created a straight slot through the centr of the two bottom screws. This allowed their removal with a straight slot screwdriver. Slide the cover straight back and off. The bulb is located on the top of the microwave connected with one screw. Replaced the bulb. It has two prongs that fit into the holder. Replace screw. Slide cover back on. It slides into retaining splines on 3 sides. Replace screws, and you're in business.
Parts Used:
Oven Lamp
  • Donald from San Marcos, CA
  • Difficulty Level:
    Easy
  • Total Repair Time:
    Less than 15 mins
  • Tools:
    Screw drivers
43 of 48 people found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
No power to microwave, no heating.
Unpluged power cord!! Removed front control panel to expose electronics (need to remove top horizontal vent cover to expose mounting hardware). Unplugged leads to control panel board. Removed magnetron with Tstat (3- phillip heads, need stubby). Installed new parts and control panel, plugged it in tested. Done.
Parts Used:
THERMOSTAT Microwave Magnetron
  • Michael from Coulterville, CA
  • Difficulty Level:
    A Bit Difficult
  • Total Repair Time:
    30 - 60 mins
  • Tools:
    Screw drivers
45 of 74 people found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!