Models
>
CDE7000A
CDE7000A Crosley Dryer - Overview
Sections of the CDE7000A
[Viewing 1 of 1]Keep searches simple, eg. "belt" or "pump".
Screw, 8/18 x 3/8
PartSelect #: PS11746840
Manufacturer #: WP90767
This screw is sold individually.
$5.42
In Stock
Timer Knob with Skirt
PartSelect #: PS11741923
Manufacturer #: WP37001184
This white timer knob and skirt assembly is used with for some clothes washers and clothes dryers. The entire assembly is three inches in diameter, and it is made of plastic. There is a gray trim arou...
$55.60
In Stock
Timer Resistor Assembly
PartSelect #: PS11740715
Manufacturer #: WP31001484
This timer resistor assembly is two inches long. It is made of ceramic and metal.
$11.10
In Stock
Timer - 120 Volts - 60hz
PartSelect #: PS11740718
Manufacturer #: WP31001513
This dryer timer is used to control the unit's cycles by regulating the length of time that power is directed to each setting.
$280.92
In Stock
Selector Knob
PartSelect #: PS2017917
Manufacturer #: 21001544
This knob accepts a D-shaped shaft.
No Longer Available
Questions And Answers for CDE7000A
We're sorry, but our Q&A experts are temporarily unavailable.
Please check back later if you still haven't found the answer you need.
Keep searches simple. Use keywords, e.g. "leaking", "pump", "broken" or "fit".
Dryer Would Not Shut Off On Its Own
Ordered my part from partselect. Com (even easier than installation) unpluged the dryer,removed all knobs from face plate ,removed three phillips head screws across top ,removed two 5/16 head screws from timer( behind cycle knob) tilted back face plate unpluged one wire at atime from old timer placed back on new timer then reverced the p
... Read more
rocess. Problem solved
Read less
Parts Used:
-
johnny from london, KY
-
Difficulty Level:Really Easy
-
Total Repair Time:15 - 30 mins
-
Tools:Nutdriver, Screw drivers
18 of 22 people
found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
no heat
removed screws (3) holding console face...then lowered console. removed timer dial knob accessing machine nuts (2) holding timer in place. removed timer and transferred all spade connections, wire-for-wire. removed old timer resistor assembly and replaced with new. reassembled everything and tested with one very wet old sock. success
... Read more
.!!!!
smiled and finished martini on the patio.
smiled and finished martini on the patio.
Read less
Parts Used:
-
walter from pittsburgh, PA
-
Difficulty Level:Really Easy
-
Total Repair Time:Less than 15 mins
-
Tools:Nutdriver, Screw drivers
8 of 10 people
found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
could noy start the dryer because the knob would not push in
the old knob slid off the post. The knob and post had one flat spot so it would be impossible to install the knob in the wrong position. Just pushed the new knob on the post and the dryer works like new again.
Parts Used:
-
mary from Prescott, MI
-
Difficulty Level:Really Easy
-
Total Repair Time:Less than 15 mins
8 of 10 people
found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!