CAC64 Waring Blender - Overview

This is a genuine manufacturer sourced replacement part used on Waring blenders. It helps to distribute the pressure evenly and provides a tight seal for the bearing holder. It is installed along with other seals and washers underneath the cutter assembly, to prevent leaks from coming out of the bottom of the container. Over time these se...Read moreals and washers will become brittle and compressed, then will have to be replaced. For proper application please refer to diagrams of your unit. This part is made out of rubber material and it is sold individually. To complete this repair you will need a wrench.

Genuine Waring replacement part, this item is sold individually. This part acts as a seal for the blenders shown below. It is installed along with other seals and washers underneath the cutter assembly, to prevent leaks from coming out of the bottom of the container. Over time these seals and washers will become brittle and compressed, then will have to be replaced.

This is an authentic manufacturer-sourced component which is made for use on Waring blenders. It provides an identical replacement for a damaged or a missing washer that was installed on a new unit. Over time the part can get damaged or lost eventually requiring a replacement. It is made of high-quality metal and is sold as an individual ...Read moreitem. Refer to the appropriate diagram for your model to ensure the correct repair procedure.

This is an authentic part that is supplied directly from the original equipment manufacturer for Waring blenders. The blade rotates on the drive shaft at a high speed, to cut the contents of the blender. This part is made of metal and is sold individually. This is also a common wear item, so we recommend ordering a spare. Be sure to wear work gloves and handle this part carefully while installing.

It is a genuine OEM supplied replacement hardware that is specially produced for Waring blenders. This is the hex nut that is secured on the bottom of the blender jar. Please note one durable metal item is included per order.

This is an authentic Waring replacement part that has been sourced from the original manufacturer and is intended to be used with blenders. The metal bearing holder is used to support the motor's spindle shaft. This item is sold as an individual replacement part.

This washer is a genuine OEM replacement part sourced directly from the manufacturer. It is commonly used in Waring blenders. This part is a small flat ring that is placed in-between the bearing holder and the bearing cap to evenly distribute the pressure. It should be replaced if any leakage occurs. It is sold individually and requires a wrench to replace.