CAC21 Waring Blender - Overview

This is a genuine manufacturer sourced replacement part used on Waring blenders. It helps to distribute the pressure evenly and provides a tight seal for the bearing holder. It is installed along with other seals and washers underneath the cutter assembly, to prevent leaks from coming out of the bottom of the container. Over time these se...Read moreals and washers will become brittle and compressed, then will have to be replaced. For proper application please refer to diagrams of your unit. This part is made out of rubber material and it is sold individually. To complete this repair you will need a wrench.

This is a genuine manufacturer approved replacement part designed for use on Waring blenders. This item fills the center hole in the outer lid. It is made out of clear plastic and it is sold individually.

Genuine Waring replacement part, this item is sold individually. This part acts as a seal for the blenders shown below. It is installed along with other seals and washers underneath the cutter assembly, to prevent leaks from coming out of the bottom of the container. Over time these seals and washers will become brittle and compressed, then will have to be replaced.

It is a genuine OEM supplied replacement hardware that is specially produced for Waring blenders. This is the hex nut that is secured on the bottom of the blender jar. Please note one durable metal item is included per order.

This is an authentic Waring replacement part manufactured for use with blenders. This lid is the outer ring used to seal the top of the blender jar. The outer lid is sold individually, please note the center lid is sold individually.

This is a genuine manufacturer-sourced part which is specially designed for Waring blenders. The coupling spins on the motor shaft to rotate the blades. This part is made of metal and is sold individually. To install you will need a wrench and screw driver. Just unscrew the drive coupling from the bottom of the blade assembly and screw the replacement on the same way.

This is an authentic manufacturer-sourced replacement container which is specially designed for use with Waring blenders. The purpose of this container is to hold the ingredients that are being blended, please note the cover and the blade are both sold separately. It is a high-quality component which is made of durable plastic and is sold individually.

The eastman container is made out of plastic and metal. This is an OEM from Waring for use in blenders. It is available as an individual replacement part. If this item becomes broken it will need to be replaced and should not require any tools during the installation.

The blending assembly goes inside the container. This part is available as an individual replacement. It is a genuine Waring replacement item for use in blenders. A set of pliers might be required during the replacement of this part. It is made out of metal and will need to be replaced if it breaks or bends.