Models > BPDH4000FS0

BPDH4000FS0 KitchenAid Dehumidifier - Overview

Sections of the BPDH4000FS0

[Viewing 3 of 3]

SECTION

Parts for the BPDH4000FS0

[Viewing 12 of 72]

Water Inlet Hose Washer

★★★★★

(2)

PartSelect #: PS11738697

Manufacturer #: WP16123

If your clothes washer is leaking, it is likely that there could be an issue with one of the hoses. If the hoses are in working order, you should check the washers connecting the hose to your unit. Ru...

$7.68

Single Hex Head Screw

PartSelect #: PS11742731

Manufacturer #: WP489069

Sold individually. The size of this screw is 1/4" hex head and 10-12 x 1/2".

$5.40

Humidistat Kit

PartSelect #: PS319194

Manufacturer #: 1166055

Switch

PartSelect #: PS406545

Manufacturer #: 999747

Full bucket switch.

Zip Tie

PartSelect #: PS11753208

Manufacturer #: WPW10339879

$7.76

Compresser Mounting Kit

PartSelect #: PS371837

Manufacturer #: 4388295

$68.76

Putty

PartSelect #: PS322282

Manufacturer #: 212643

Permagum sealer for refrigerant line insulation.

$50.66

Strip Seal

PartSelect #: PS318136

Manufacturer #: 1158732

Start Relay

★★★★★

(1)

PartSelect #: PS380234

Manufacturer #: 598215

VALVE

PartSelect #: PS403685

Manufacturer #: 978030

$47.84

Valve, Access (1/4``)

PartSelect #: PS11747411

Manufacturer #: WP978025

$37.60

Access Valve - 5/16 Inch

PartSelect #: PS403669

Manufacturer #: 978026

$41.15

Questions And Answers for BPDH4000FS0

Be the first to ask our experts a question about this model!

Common Symptoms of the BPDH4000FS0

[Viewing 1 of 1]

Leaking

Fixed by
these parts

Show All

Installation Instructions of parts on the BPDH4000FS0

[Viewing 2 of 2]

The humidifier would run continuously regardless of the humidity setting.

I removed the old humidistat and replaced it with the new one which was an exact fit.

Parts Used:

Humidistat Kit

Stephen from Richfield, NC
Difficulty Level:
Easy
Total Repair Time:
Less than 15 mins
Tools:
Nutdriver, Pliers

1 person found this instruction helpful.

Was this instruction helpful to you?

Thank you for voting!

Dehumidifer collection pan (bucket) overflowing with water

The unit should cutoff when the pan gets full enough for it to depress the pan full switch on the back of the unit. Used an ohm-meter to check and see that this switch was bad. Replaced with this part and now it cuts off again when the pan is full. Not hard at all. Take the cover off the unit (screws) then take the switch out (nut) and replace.