BM905000 Homelite Generator - Overview

This is is a genuine OEM sourced replacement brush assembly designed for use with generator motors. This assembly secures carbon brushes around the armature and provides stable and safe contact. This assembly includes: plastic holder, two (2) carbon brushes with lead wires and springs attached. To replace this assembly you would need a s...Read moreet of wrenches. • First remove screws holding the cover together • Carefully separate housing to gain access to armature and brush holder • Disconnect wires from old brushes • Remove old brushes and install the new assembly • Reassemble and test the motor

This authentic manufacturer-sourced part is specially designed for use with portable generators. It is an identical replacement for a missing or a faulty component that was installed on a new unit. The part helps to secure fuel tank to the main frame, please make sure to refer to the appropriate diagrams of your model for the correct loca...Read moretion and application of this hardware. Keep in mind this high-quality isolator is made of durable rubber and is sold individually.

This is a genuine Homelite, Ridgid, and Ryobi replacement part for use in generators. The fuel cap attaches to the fuel tank. No tools should be needed during the replacement of this part. It is made out of metal and will need to be replaced if it breaks. This item is sold individually.

The fuel tank vapor vent attaches to the bushing rollover valve and the fuel tank. This is a genuine Homelite and Ridgid part sourced directly from the manufacturer for use in generators. It is sold individually and is made out of plastic. During the installation process, a wrench and a set of pliers might be needed to replace this item. This part will need to be replaced if it breaks.

This is an authentic Homelite replacement part. The outlet cover is designed by the manufacturer for use in portable generators. This part is made of flexible rubber, and is attached to the cover plate to protect the duplex receptacle outlets when not in use. You will require a screwdriver when replacing this part. This item is sold individually.

This authentic item is supplied directly from the original equipment manufacturer for use with pressure washers and generators. The wear pad is made of hard rubber and attaches to the foot bracket with a washer and a bolt. It may require a wrench during replacement if the part becomes broken. The pad is sold individually and helps to reduce vibrations and cushion the bracket.

This is an authentic replacement part, sourced from the original manufacturer for use with generators. This metal washer is commonly used to provide spacing between a bolt and the outside of the foot assembly. The washer is available as an individual replacement part, please note four washers may be required.

This is a genuine replacement part sourced directly from the manufacturer. The outlet cover is found on generators from Homelite and Husky. This part is made of flexible rubber, and can be flipped down to cover the twist lock receptacle when not in use. You will require a screwdriver when replacing this part. This item is sold as an individual replacement part.