BM10711D Homelite Generator - Overview

This is is a genuine OEM sourced replacement brush assembly designed for use with generator motors. This assembly secures carbon brushes around the armature and provides stable and safe contact. This assembly includes: plastic holder, two (2) carbon brushes with lead wires and springs attached. To replace this assembly you would need a s...Read moreet of wrenches. • First remove screws holding the cover together • Carefully separate housing to gain access to armature and brush holder • Disconnect wires from old brushes • Remove old brushes and install the new assembly • Reassemble and test the motor

This OEM replacement washer is a thin, flat, round-shaped metal disk with a hole in the center, used in a variety of outdoor power equipment. It is made of steel and has an inner diameter of 0.25 inches. Washers are designed for use with fasteners such as bolts or screws to distribute the clamping force of the fastener and provide additio...Read morenal security to the parts being fastened. Additionally, they protect the surface they are positioned on from damage and can be used to align/level various components. You will need to replace your washer if it is corroded, cracked, or worn down. Each washer is sold individually.

This is a genuine manufacturer-approved replacement wheel which is specially designed for Homelite generators. It is one of the wheels used to support the equipment and allow for easy transportation. Please note this high-quality component is sold individually, it consists of a durable metal rim and a rubber tire. Keep in mind the hardware to secure it sold separately.

This part is a 20 amp, 120 volts AC, circuit breaker which also includes two metal Phillips-head screws, two washers, and a bolt. The circuit breaker goes in the stationary control panel box and is designed to cut off the power if there is an overload. This metal part is an OEM for use in generators. It is time to replace this circuit breaker if the button is out and remains out even after being pushed in.

This item is a genuine OEM sourced replacement part that is intended to be used with portable generators from Homelite and Husky. The fuel shut off valve attaches to the tank and is used to control the flow of fuel to the fuel line. This item includes a filter that will remove contaminants from the fuel that enters the engine. This item is priced as a single item.

This replacement automatic voltage regulator is sourced directly from original equipment manufacturer for use with Homelite and Ridgid generators. It regulates the output voltage of the generator by limiting the amount of voltage in the electrical system. Please note this high quality item is sold individually.

The twist lock receptical fits between the cover plate and the circuit breaker. This is an authentic Ridgid, Homelite, and Husky replacement part that is sourced from the original manufacturer for use with generators. This part is available individually and is made out of plastic and metal. You may need a screwdriver when replacing this part. It will need to be replaced if it becomes broken.

It is a genuine item that is supplied directly from the original equipment manufacturer for use with Ridgid, Homelite and Husky generators. It provides an identical replacement for a missing or a faulty fuel tank bushing that was installed on a new unit. This is one of the special bushing utilized to mount the fuel tank. Please make sure ...Read moreto refer to the appropriate diagrams of your model for the correct location and application of this hardware. Keep in mind this high-quality bushing is made of durable rubber with metal and is sold individually.