This is the replacement charcoal filter for your microwave. It is silver and black in color and measures approximately 10 inches by 2 ½ inches. The charcoal filter removes cooking odors from the air that circulates through the microwave vent. You will likely need to replace the charcoal filter if you notice any damage to it, or if it has...Read more been in your microwave for a long time. This part is sold individually and is an authentic OEM part sourced directly from the manufacturer.
This is a genuine replacement 40 watt bulb for a microwave. The bulb is meant to light up the underside of the microwave or inside of your microwave when the door is open or during use. If your bulb is not illuminating, you may need to replace it. If the bulb is shattered, be sure to use protective gloves during replacement. Always unplug...Read more your microwave before completing any repairs. We suggest ordering a spare, as this is a common wear part.
This light socket is for your microwave and is designed to hold the light bulb. If the light bulb is not working, and the bulb has not burned out, it may be a problem with the light socket. This part is an authentic OEM part sourced directly from the manufacturer. Be sure to disconnect power from the microwave, and consult the manual for your microwave before you make this repair.
This 13.5-inch glass turntable tray is designed to fit a variety of microwave models, particularly those from GE and Hotpoint. Constructed from food-safe, heat-resistant tempered glass, it ensures consistent and even heating by rotating food during operation. The tray features a smooth surface and a sturdy build for long-term durability. ...Read moreOn the underside, it includes three distinct grooves that align precisely with the microwave’s central bushing coupler, allowing secure placement and smooth rotation. The outer diameter of the tray is approximately 13.5 inches, while the recessed track underneath measures about 10.25 inches across, ensuring compatibility with standard
This fast-blow glass fuse is a genuine replacement component designed to protect microwave ovens from electrical damage caused by power surges or internal malfunctions. Rated at 20 amps and 125 volts, it interrupts the power supply when excessive current is detected, helping to safeguard sensitive internal components. Measuring approximat...Read moreely 6x30mm (0.24 x 1.18 inches), this fuse is compatible with a wide range of microwave models from GE, Hotpoint, and Frigidaire. Replacing a blown fuse is a common repair when a microwave fails to power on or experiences intermittent electrical issues. Always confirm compatibility with your specific model before installation.
This fan thermostat monitors temperature and activates the cooling fan when heat levels rise, helping protect internal components. Replacement is recommended when the fan does not turn on or temperature regulation becomes unreliable.
1. Unplug unit 2. Open door, remove two screws above the top trim piece, slide and remove trim. 3. Remove screw behind control board and top left corner, then release from position. 3b. Unplug all wire terminations and set control panel aside. 4. Remove two screws securing latch board, lift and rotate board
... Read moreout of position, remove three micro switches, xfer monitor switch actuator from lower pin in old board and insert in new. Install new door switches and reverse procedure to complete repair.
Note 1. Take care to located new latch board so holding tabs line up, pass through frame, and openings for door tangs line up with openings in frame before securing with screws.
Note 2. A long magnetic screwdriver is helpful.
Read less
Was this helpful?
Thank you for voting!
Had to replace charcoal filter
15 of 25 peoplefound this instruction helpful.
Jared from SIERRA VISTA, AZ
Easy
15 - 30 mins
Open the front cover by pushing it at the top (where it says “Push”), lifting up and pushing back on top edge of the old filter. Pull it out. Installing the new one is basically just the reverse of those steps! That simple.
Old filter did seem to be a little thicker (filter material), but the new one was the exact same dimen
... Read moresions, so it went in properly. Wish the filter material was white, so you knew just how dirty it was actually getting. But... :-D