AR907511P Ariens Generator - Overview

This vapor vent, also known as a vent valve or vent cap, is supplied by the original manufacturer for use with generators. It is designed to provide ventilation for the fuel tank by allowing air to enter and leave the tank as necessary. The vent prevents pressure from building up in the tank and interfering with the flow of fuel. Over tim...Read moree the vent may become clogged, or damaged leading to hard starting, fuel leakage, stalling, and the release of harmful gases into the atmosphere. It is recommended to inspect the vent before each use and replace any blocked vent promptly. To complete this repair, remove the faulty vent from the fuel tank and clean the mounting area. Thread the new vent on to the tank and ensure it is locked in place.

This fuel shut-off valve, also known as a fuel valve or fuel selector valve, is an OEM replacement part designed for use in generators. The valve controls the flow of fuel to the engine. When the valve is in the on position, fuel flows to the engine, enabling it to run. When the valve is in the off position the flow of fuel stops and the ...Read moregenerator shuts down. Over time the valve may become clogged or damaged, and unable to fully close or open. Once the fuel shut off valve is no longer functioning, the generator will leak fuel, and may have difficulty in starting or running. Before replacing the valve, first disconnect the fuel line and place a container below the fuel tank to allow the fuel to drain out. Detach the old fuel shut off valve and install the new one in its place. Apply thread sealant to the new valve for a good seal and reattach the fuel line. Refill your tank with fresh fuel and run the equipment to ensure there are no more leakages.

This is an authentic Homelite replacement part. The outlet cover is designed by the manufacturer for use in portable generators. This part is made of flexible rubber, and is attached to the cover plate to protect the duplex receptacle outlets when not in use. You will require a screwdriver when replacing this part. This item is sold individually.

This authentic item is supplied directly from the original equipment manufacturer for use with pressure washers and generators. The wear pad is made of hard rubber and attaches to the foot bracket with a washer and a bolt. It may require a wrench during replacement if the part becomes broken. The pad is sold individually and helps to reduce vibrations and cushion the bracket.

This is a genuine OEM sourced part which is specially made for use with Homelite and Ridgid generators. The switch is an important component that allows a user to turn the equipment on and off, unfortunately, over time parts will wear out and may begin to fail eventually requiring a replacement. Please make sure to check the diagrams of y...Read moreour model for the correct location and application of this part. Keep in mind this high-quality plastic body switch is sold individually.

It is a genuine item that is supplied directly from the original equipment manufacturer for use with Ridgid, Homelite and Husky generators. It provides an identical replacement for a missing or a faulty fuel tank bushing that was installed on a new unit. This is one of the special bushing utilized to mount the fuel tank. Please make sure ...Read moreto refer to the appropriate diagrams of your model for the correct location and application of this hardware. Keep in mind this high-quality bushing is made of durable rubber with metal and is sold individually.