This water filter is a genuine replacement for bottom-freezer refrigerators that accept a Filter 2. it is certified to remove up to 24 different contaminants which include pharmaceuticals, waterborne parasites, lead, and pesticides. The filter should be replaced every six months, or when 200 gallons of water have passed through, to ensure...Read more optimum contaminant reduction. The filter is found in the top right corner of your fridge, and replacing it is easy. Simply pop out the old one (keep a bucket underneath to catch any water) and slide in the new one. You will hear a click once it has locked into place. You should run water through the filter for a couple minutes prior to use. This filter measures approximately two inches wide, two inches deep, and 7.5 inches long.
This Refrigerator Ice Maker Installation Kit connects the house water supply, to the refrigerator for ice maker and water dispenser operation. This kit includes 15-ft of copper tubing, (1) saddle valve, tape, and (1) tubing connector.
The water filter housing holds the filter and connects the water lines, so a leak may point to damage here. Confirm this OEM refrigerator part fits by checking your appliances model number. Unplug the refrigerator before replacing it. Remove the water filter, then the reservoir access panel screws using a 1/4-inch socket or nut driver.
This limit switch monitors operating conditions and interrupts power if preset limits are exceeded, helping protect internal components and ensure safe operation. It is commonly replaced when safety circuits prevent the appliance from running properly.
Supply power to connected refrigerator systems with this electronic control and power supply board. It supports cooling and defrost operation by distributing electricity to components and working with the appliance controls. A faulty board may cause interrupted cooling, erratic cycling, a dark display, or components that fail to operate. ...Read moreReplacing a failed board helps restore proper electrical supply and system operation. Unplug the refrigerator before accessing the board, handle it by the edges to protect its circuitry, and reconnect each wiring plug securely during installation. This is an OEM part sourced directly from the manufacturer.
See how others fixed this model. Time, tools, difficulty, and steps that lead to victory!View More
Search repair tips from other customers using simple keywords like "replace", "fit", "remove", "inspect". DIY doesn't mean you have to do it alone!
Search filter:
Clear Filter
Your search term must have 3 or more characters.
Quit making ice
23 of 37 peoplefound this instruction helpful.
Wyn from SURPRISE, AZ
Really Easy
30 - 60 mins
A repair man came out and had to replace the ice maker
Was this helpful?
Thank you for voting!
Switch went bad
12 of 18 peoplefound this instruction helpful.
Roy from Ann Arbor, MI
Easy
15 - 30 mins
Nutdriver, Pliers
Our unit is a built-in unit so first had to remove the decorative cover panel to expose the internal on/off switch. Turned off the circuit breaker. Disconnected the wires (simple pull-off/push-on). Removed the old switch which meant clipping the plastic tabs holding the switch in position. Inserted the new switch by simply pushing it thro
... Read moreugh the opening being sure to have it in the same alignment ('off' to the back of the unit.) Reconnected the wires making sure to have a white ground wires on the left and the black 'hot' wires on the right. Turned the circuit breaker back on. Turned the switch on. Now it runs.
Read less
Was this helpful?
Thank you for voting!
Putting in a new water filter
8 of 12 peoplefound this instruction helpful.
Denise from WILBRAHAM, MA
Very Easy
Less than 15 mins
Unscrewed the old one and put the new one in Some water on shelf of fridge Overall not bad