This click spring is sourced directly from the original equipment manufacturer for use with Shimano fishing reels. It is an important component that helps to apply tension on the click pin. This is a part of the click-drag mechanism that prevents the line from overextending under a heavy load. Over time it may wear out and lose tension ev...Read moreentually requiring a replacement. To ensure the correct installation of this hardware, check the diagrams of your specific model. Keep in mind this high-quality click spring is made of durable metal and is sold individually. You may need pliers and a screwdriver to perform this repair.
This authentic component is an OEM part which is designed for Shimano fishing reels. It is an important part of the drag mechanism that applies tension on the line preventing it from reeling out too fast. This is an identical replacement for a damaged or a faulty hardware that was installed on a new unit. One durable metal click pin is in...Read morecluded. Check the diagrams of your model for the exact location and the correct installation of this component. Replacing it will require a screwdriver in order to remove and reattach the side cover. Note, other parts of the drag mechanism are all sold separately.
See how others fixed this model. Time, tools, difficulty, and steps that lead to victory!View More
Search repair tips from other customers using simple keywords like "replace", "fit", "remove", "inspect". DIY doesn't mean you have to do it alone!
Search filter:
Clear Filter
Your search term must have 3 or more characters.
No Power to Microwave
42 of 89 peoplefound this instruction helpful.
John from Palos Hills, IL
Really Easy
Less than 15 mins
Screw drivers
After determined the problem on one of the websites...I received the part I needed... removed the control panel and installed the new main fuse In about 15 mins!
Was this helpful?
Thank you for voting!
Microwave did not work; no clock, etc. 120VAC at duplex outlet OK. Thought there must be an internal in line fuse or reset.
3 of 3 peoplefound this instruction helpful.
Lisa from DURHAM, NC
Very Easy
Less than 15 mins
Screw drivers
Unplug microwave! It's NOT necessary to remove microwave from above stove. Removed two Philips head screws on top front of unit to remove front grille. Removed one screw to remove control panel, letting it hang down. Found inline fuse in cabinet where line cord wires come in. Pulled out blown fuse with thumb and forefinger. Snapped in new
... Read more fuse, replaced control panel and grille with the three screws. Plugged in the microwave. -Worked great! Good opportunity while grille was off to clean it and replace the charcoal filter inside the cabinet.
Read less
Was this helpful?
Thank you for voting!
Power Went Completely Out
2 of 2 peoplefound this instruction helpful.
Brittney from LUFKIN, TX
Very Easy
15 - 30 mins
Pliers, Screw drivers
The power on the microwave went completely out when I went to use it, but there was no power failure for the house or neighborhood. We removed the microwave from above the oven. Took out the screws on the sides and back of the microwave and slid the top back. The line fuse was located on top unobstructed, NOT behind the button panel li
... Read moreke some microwave models. As the appliance is over 20 years old the line fuse was quite old. It was really hard to pry it out of its holder and actually broke. I used a vacuum to suck up the dust and glass and it was easier to get out the ends once the middle broke. Popped the new line fuse in, slid the top back on, put in the screws and put the microwave back in its compartment above the stove. Good as new!! We were about to spend money on a new microwave, but thankfully I came across this site. So happy I did!!
This repair was really easy. The part that took the most time was taking it down from it's compartment above the oven and putting it back up there once repaired.