AH- - Overview

This deep-groove ball bearing is a durable replacement component designed to support smooth, high-speed rotation in power-driven equipment. Featuring a double metal-shielded design, it helps keep contaminants out while retaining internal lubrication for quieter operation and extended service life. Manufactured from hardened steel and pre-...Read morelubricated for immediate use, the bearing is built to handle continuous motion and demanding operating conditions. It is commonly replaced when excessive noise, vibration, or reduced efficiency indicates bearing wear, helping restore reliable, low-friction performance in moving assemblies.

This is a genuine replacement part that has been sourced from the original manufacturer to be used with table saws, panel saws, spindle sanders, and air hoists from Powermatic and Jet. The metal ball bearing is used to limit friction between a rotating shaft and a fixed part assembly. The ball bearing is sold as a single replacement part.

This is an authentic Jet replacement part. It is used in Air Hoists. The vanes slot into the rotor, causing the rotor to spin when air pressure is applied. The part is made of hard laminated layers of fabric and plastic, designed to avoid damage to the casing. You will need a screwdriver to replace this part, as you will need to remov...Read moree the rear housing to reach it. It is recommended to replace all the vanes in the rotor at the same time for even wear. This part is sold individually.