AGD1 Air Conditioner - Overview

Models starting with AGD1

Click on the best match to narrow your results.

Parts for models starting with AGD1

$46.34

Remote Control Assembly

★★★★★

(6)

Part #AKB73795706

This remote control is a device for adjusting your air conditioner settings. It requires two AAA batteries for operation. A malfunctioning remote control may have unresponsive buttons or signs of physical damage. You may also notice that your air conditioner does not consistently or promptly respond to commands from the remote control. Yo...Read more

Read less

Fan Assembly,Axial

★★★★★

(3)

Part #5900AR1173A

The fan assembly or condenser fan blade fits on the motor shaft and circulates air over the condenser. This cools the refrigerant before it enters the evaporator. If the fan assembly in your room air conditioner is not operating properly, you will need to replace it with this part. This fan assembly has 5 blades and is approximately 14-1/...Read more

Read less

$60.51

Room Air Conditioner Installation Kit

★★★★★

(2)

Part #3127A20074Y

The installation kit contains the hardware you need to install the room air conditioner.

$8.55

Damper,Compressor

Part #4H00982E

Frame Guide - Black

★★★★★

(1)

Part #WJ05X10024

This part attaches to the curtain to help hold it in place.

Condenser Fan Blade

Part #WJ73X10016

FILTER,AIR

Part #5231AR1152Y

Fan Blower

Part #WJ73X10072

REMOTE CONTROLLER Assembly

Part #WJ26X10049

Thermistor,NTC

Part #6323A20003F

BRACKET SILL SUPPORT

Part #WJ01X10074

$21.45

CLAMP SPRING

Part #WJ03X10019

Repair Tips From Fixers Like You

See how others fixed this model. Time, tools, difficulty, and steps that lead to victory! View More

Fan blade was broken

4 of 4 people found this instruction helpful.

Jonathan from Baltimore, MD
A Bit Difficult
1- 2 hours
Pliers, Screw drivers

Took cabinet off. Loosened rear condenser and moved it out of the way. Took fan blade off of motor shaft and replaced. Actually broke off small part of blade hub tapping it on to the shaft with a hammer - use a block of wood to protect!

Was this helpful?

Motor mount broke due to imbalance caused by mud dobber nests.

1 person found this instruction helpful.

Travis from LOUISVILLE, IL
Easy
30 - 60 mins
Nutdriver, Screw drivers

Pulled PTAC out of wall sleeve, unhook wire harness from control area, remove condenser shroud and motor and fan blade all at the same time. Replaced motor bracket and re-installed in reverse order.

Was this helpful?

fan had stripped out and was replacing.

1 of 10 people found this instruction helpful.

Douglas from ENGLEWOOD, TN
Very Difficult
1- 2 hours
Pliers, Screw drivers, Socket set

very tight working situations. made a mistake with a delicate piece of the fan and broke it and that rendered the part unuseful. Since I broke it I considered it to be my fault and just threw it away. Ordered another from another company hoping that just maybe it would be more durable. It arrived in only 4 days. Yours took well over ... Read more

Read less

Was this helpful?