AGC2 (22585) Andis Clipper Trimmer - Overview

This part is manufactured by Andis. This Hinge Assembly is used on many models of Andis hair clippers. The Hinge Assembly includes the Blade Lock (part number 64537). This part holds the cutting blades into place while cutting hair. If the blade feels loose or won't stay in place, then the Hinge Assembly needs to be replaced. To replace t...Read morehis part two Blade Hinge Screws (27864) will need to be removed. A Philips screwdriver is all that is needed for the replacement of this part.

This is a genuine OEM sourced replacement part designed for use with Andis clippers. This assembly includes one (1) carbon brush with a lead wire attached. Please note brush spring and retaining clip are both sold separately. Due to normal use and friction brushes will gradually wear down and will require replacement. It is advised to re...Read moreplace both brushes at the same type. You would need a screwdriver to complete this job. • Make sure the unit is unplugged • First remove cover • Take our old brushes and replace them with the new ones • Secure the cover and test the tool

This genuine manufacturer-sourced part is specially made for use with Andis clippers. The armature is the main portion of an electric motor which rotates the shaft. You'll need to replace the armature if you notice smoke or sparks coming from the vents on the back of your equipment. If this happens, you've probably overloaded your armatur...Read moree and some point, which caused the insulation to break down. It provides an identical replacement for a faulty or a missing component that was installed on a new unit. Check the owners manual and the diagrams of your specific model for the correct installation of this armature. Note, this high-quality part is sold individually.

Quad Force Blade Drive Assembly

This is a genuine OEM sourced replacement part, not an aftermarket equivalent. It is specially manufactured for use with Andis clippers. It is used to secure the quad blade drive assembly. This part is made out of metal and it is sold individually. You will need a screwdriver to install or remove this screw.

This is a genuine Andis part. This PC Board is used in many models of Andis clippers. The Board is configured for two speeds. This part should be replaced if there is no power getting to the motor. One indicator that the Board has gone bad is if the resistor is discolored or burned out. Other parts that are commonly purchased with this pa...Read morert are the Brushes (part number 27847), Armature (27072), and the Power Cord (64250).

It is a genuine OEM blade-hinge screw that is specially produced for Andis clippers. Two of these screws are usually used to secure the blade and the hinge assembly, for correct location and use of this hardware make sure to check parts diagram of your model. It is a high quality item that is sold individually.