This control knob may also be known as the selector knob or the room air conditioner rotary switch knob, and is compatible with your room air conditioner. The part will allow you to shift the rotary s...
$48.38
In Stock
Order within the next 6 hrs and your part ships today!
This part is located on the drum roller support shaft in your dryer appliance. The exterior of the washer is 1 inch in diameter with a hole in the middle and is made of metal. They are installed along...
$18.58
In Stock
Order within the next 6 hrs and your part ships today!
This hex nut is an authentic Whirlpool part that is sourced directly from the original equipment manufacturer, and will fit a variety of appliances including ovens, microwaves, refrigerators, air cond...
$9.56
In Stock
Order within the next 6 hrs and your part ships today!
This motor clip is an original manufacturer replacement clip used to secure the motor in your home appliances. It holds the motor firmly to its housing to prevent shaking and potential damage while th...
$21.62
In Stock
Order within the next 6 hrs and your part ships today!
Silicone rubber adhesive is a high temperature adhesive that is used for gaskets on dryers and felt seals. It is used on many different appliances for many different application reasons. This silicone...
$51.96
In Stock
Order within the next 6 hrs and your part ships today!
Well - first I thought the problem was the capacitor, as that will cause hard starts, especially on an air conditioner (I am no HVAC man, but researched this to find out). Pulled the capcitor (BE CAREFUL - discharge first - It CAN kill you if you don't!). Tested it and found it fine (again - to test - research on the net - VERY easy w/
... Read morea standard Ohm meter).
So - after investigating a few other possibilities, I sat and listened to the thing run and realized it was cycling too fast (trying to kick the compressor on too close to shutting it off, hence the built up pressure was still too high to kick the compressor on easily. Figured maybe the thermostat was causing this (kicking the compressor on before it was "rested").
I was correct. It solved the problem.
To change the thermostat took like 5 minutes.
BTW - CLEAN YOUR COILS - I'M SURPRISED MY WAS EVEN RUNNING! THE COILS WERE FULL OF JUNK. If your coils are dirty the thing is will not run well and will cost you a lot of money to make your room / house cool!
Removed the back - Saw the broken clips on the base of the dryer (the wires to the motor were pulling out because the motor was slipping).
Guessed that the parts were motor clips (no pix in the web site!)
Got the parts in post - they were identical except needed some rubber grips inside to hold tight (Used pieces of
... Read morebike tire inner tube cut to fit for this.) Attached clips. Works fine!!
(Son is an engineer - he found the problem. Husband is a retired doctor - he couldn't!! but together they supplied the muscle) Sue (67 years old)