This control knob may also be known as the selector knob or the room air conditioner rotary switch knob, and is compatible with your room air conditioner. The part will allow you to shift the rotary s...
$48.38
In Stock
Order within the next 9 hrs and your part ships today!
This part is located on the drum roller support shaft in your dryer appliance. The exterior of the washer is 1 inch in diameter with a hole in the middle and is made of metal. They are installed along...
$18.58
In Stock
Order within the next 9 hrs and your part ships today!
This part is sold individually. The air filter is part of your room air conditioner and prevents dirt, dust, and other debris found in the air from getting inside your home. Over time this part can be...
This hex nut is an authentic Whirlpool part that is sourced directly from the original equipment manufacturer, and will fit a variety of appliances including ovens, microwaves, refrigerators, air cond...
$9.56
In Stock
Order within the next 9 hrs and your part ships today!
This motor clip is an original manufacturer replacement clip used to secure the motor in your home appliances. It holds the motor firmly to its housing to prevent shaking and potential damage while th...
$21.62
In Stock
Order within the next 9 hrs and your part ships today!
Silicone rubber adhesive is a high temperature adhesive that is used for gaskets on dryers and felt seals. It is used on many different appliances for many different application reasons. This silicone...
$51.96
In Stock
Order within the next 9 hrs and your part ships today!
A zip tie, also known as a cable tie or a wire tie, is a fastening device that holds wires or tubing together. If a machine has wires or tubing that are easily shifted, you need to hold them tightly t...
$8.04
In Stock
Order within the next 9 hrs and your part ships today!
First removed the power and front panel. Then in order to get to the damaged cooling selector switch, I needed to first drill out three riviets holding the small front pannel that the switch and thermostat selector switches are mounted on.
Then it was a simple matter to unscrew two small screws holding the broken cooling selec
... Read moretor switch in place.
At this point, I unhooked each wire (about 7 of them) from their terminal connector on the back of the switch, and reapplied each to the new switch. After I was done I then mounted the new switch with the two screws and realigned the pannel.
The only thing remaining was to install the small pannel using three pop rivets and slide on a new knob, and reinstall the large A/C front cover.
FYI, The new replacement switch and knob were perfectly identical, and worked like a charm.