Quick Question!

Have you ever purchased from PartSelect.com before?

Models > ACC4370AW

ACC4370AW (PACC4370AW0) Amana Cooktop - Overview

Get Parts and Repair Help for ACC4370AW

If you know the cooktop repair part you need, you can browse the list of all parts on the ACC4370AW, or you can search by name or part description. You can also find your part by where it is located on the ACC4370AW by selecting a section below. If you’re not sure which part you need, you can narrow your search by selecting a common symptom and we’ll show you the repair parts most likely to fix your cooktop. Installation instructions provided by other do-it-yourselfers will help guide you through your repair.

Sections of the ACC4370AW

[Viewing 2 of 2]
Search for parts
Keep searches simple, eg. "belt" or "pump". Need help?


Sold individually.


Surface Element - 1500W

This surface element is made for under glass set-ups and supplies the heat to a cooking area on top of the range. It has an outside diameter of approximately 7 inches (1500 watts), and is a genuine OEM part sourced directly from the manufacturer. Before you replace your faulty element, make sure the element is cool, and the power is disconnected from your range.


Surface Infinite Switch


Variable Fan Speed Control


Surface Ribbon Element with Limiter - Small

This is a 1200 watt / 240 volt surface element.


Dual Element Infinite Control Switch



This screw is sold individually. Size: 8-32 x 1/4 inch.




Common Symptoms of the ACC4370AW

[Viewing 1 of 1]
Search Instructions
Keep searches simple, eg. "belt" or "pump". Need help?

Burner switch failed (full on, even in "lo")

  • Customer: Stephen from Seneca, SC
  • Difficulty: Easy
  • Time to Complete: 1- 2 hours
  • Tools Required: Pliers, Screw drivers
  • 20 of 30 people found this instruction helpful
Managed to reach down from the top, unscrew the old part, so I could remove from under the cooktop. Easy to trace the wires, and map them to the (slightly different) replacement. Works like a charm, and new part appears to be of higher quality than the old one. read more

knob stem broke off switch

  • Customer: TODD from PALOS HEIGHTS, IL
  • Difficulty: Easy
  • Time to Complete: 30 - 60 mins
  • Tools Required: Screw drivers
  • 9 of 10 people found this instruction helpful
I had to remove the 18-22 screws that held in the top of the stove. Then remove the nut that held the switch in place. I took a pictures as I went with my camera phone. That way I remembered which wires went where. Since there was a two day lag getting the part, i was afraid that I would forget. Once I received the part, I just reversed the process. Hardest ... read more

Small burner full hot all the time.

  • Customer: RICHARD from PARADISE, TX
  • Difficulty: Really Easy
  • Time to Complete: 30 - 60 mins
  • Tools Required: Screw drivers
  • 16 of 36 people found this instruction helpful
TURNED OFF POWER TO STOVE Removed 5 Knobs, 2 screws that held bad switch.
Removed 4 screws and lifted panel up and forward to expose switches. Adjusted spring tension on knob stem to hold knob ( stem in new switch slightly smaller) removed wire from defective switch one at a time and fastened to new switch in sequence. Reassembled and turned... read more