This evaporator fan motor is in the back of the freezer, and circulates air over the refrigerator coils. These coils will convert the heat into cool air, which is then circulated. When the evaporator fan motor fails, it often generates a lot of noise in the freezer area. If you notice that your refrigerator or freezer is noisy, or is not ...Read morecooling like it should, you may need to replace the evaporator fan motor. The base of this part is approximately 3 inches in length and 2 inches in width. The shaft of this part is an additional 2 inches in length.
This genuine OEM water filter is made for your side-by-side or French door refrigerator, working to reduce impurities like iron, chlorine, and rust for better-tasting water. With a capacity of 300 gallons, it is easy to install with a rear mount design, saving space in your fridge. If the filter gets damaged or clogged, you might notice s...Read morelower water flow or odd tastes. We suggest swapping it out every six months. Sign up for our water filter subscription plan for automatic replacements.
This roller wheel axle pin (part number DA61-01920A) is for refrigerators. Roller wheel axle pin DA61-01920A attaches the roller wheel to the roller wheel bracket. Wear work gloves to protect your hands during the repair.
This manufacturer-approved screw is for refrigerators, including Kenmore refrigerator model. Avoid cross-threading refrigerator screw during installation.
See how others fixed this model. Time, tools, difficulty, and steps that lead to victory!View More
Search repair tips from other customers using simple keywords like "replace", "fit", "remove", "inspect". DIY doesn't mean you have to do it alone!
Search filter:
Clear Filter
Your search term must have 3 or more characters.
freezer was cold fridge was not
15 of 32 peoplefound this instruction helpful.
theodore from PUEBLO, CO
Really Easy
30 - 60 mins
Screw drivers
Took shelving out of freezer removed panel. Took second panel out and removed motor. Whole repair took 45 minutes. Works perfect
Was this helpful?
Thank you for voting!
Refrigeration side was not cold enough.
1 of 3 peoplefound this instruction helpful.
Ductri from RESEDA, CA
A Bit Difficult
More than 2 hours
Screw drivers
Replaced the Broken Cover Motor and the Fan Blade. Fan motor was test with 12VDC power supply, or by replugging fan connector and holding down the door closing switch.
After a few days, the fan made loud noise. Due to defrog heater was open when it was test with ohmmeter. Ice deposited around the fan.
I had to buy
... Read more a whole ASSY EVAP-REF part # DA96-00395C, and seperated the evaperator, and replaced the heater and sensor. Spray bottle was used spray hot water to de-iced the evaperator. And salt accelerated the ice melting process.
Note: spray water to clean salt before installing new parts