ABS (Series) Mi-T-M Compressor - Overview

This is an OEM part sourced directly from the manufacturer. The breather assembly is commonly found on Mi-T-M air compressors. This part is made of high quality plastic, and is connected to the rear crankcase cover to allow excess air to escape the crankcase, while preventing unfiltered air from flowing back in. No tools are required w...Read morehen replacing this item. Simply remove the old part and screw the new one in its place. This item is sold individually.

It is a genuine component that is supplied by the original manufacturer for use with Mi-T-M air compressors. This decal contains the Mi-T-M logo and sticks into place on the air compressor therefore, no tools are required to install or replace it. This part is made of plastic and is sold individually.

This authentic item is supplied directly from the original equipment manufacturer for use with compressors and generators made by Mi-T-M. The air filter is part of the filter assembly. A set of pliers may be necessary during the installation of this part. It is made out of plastic and metal and will need to be replaced if it breaks or becomes dirty. This item is sold individually.

This is a genuine OEM part. The petcock is constructed of metal, and is an important component to many air compressor tanks. Fitted onto the tank, this item is designed to drain the excess water. The repair may require a wrench to install, and the petcock is sold individually.

The turn fastener goes next to the grommet and is made of metal. It is a genuine OEM sourced part which is specially designed for use with Mi-T-M pressure washers. This item is available as an individual replacement. A screwdriver might be necessary during the installation of this item. This part may become broken and will need to be replaced.

The throttle control is made out of metal. This authentic item is supplied directly from the original equipment manufacturer for use with compressors made by Mi-T-M. This part is sold individually. A wrench might be helpful during the installation of this part. It will need to be replaced if it breaks.