If the center crisper rail is cracked and no longer supports the crisper shelf, replace it with this OEM refrigerator rail. It sits between the crisper drawers and supports their inside edges as they slide in and out. Installation requires no tools.
If your refrigerators interior light is not working, the door switch may be the cause. It turns the light off when the door closes. This is an OEM part. Confirm compatibility using your refrigerators model number.
The refrigerator light and fan circuit uses this three-terminal rocker arm switch. It is an OEM replacement part. Disconnect power before working on this electrical part.
This is a multi-use and multi-appliance screw. It can be used on a microwave, refrigerator, range/oven, air conditioner, dehumidifier, washer, or dryer. The measurements of this screw are 8 x 1/2 inch. It has 6 threads. Refer to the manual provided by the manufacturer for further information on repair and accurate guidance. Remember to wear work gloves as a safety precaution.
Carry defrost water away from the freezer with this refrigerator drain tube kit. It directs melted frost into the drain pan beneath the appliance, where the water can evaporate. The updated curved tube replaces older drain designs that can clog and cause water to back up. A blocked or damaged drain may lead to ice on the freezer floor or ...Read morewater leaking beneath the refrigerator. Installing the kit helps restore proper drainage. Unplug the refrigerator before accessing the lower rear compartment. This is an OEM part sourced directly from the manufacturer.
This refrigerator crisper drawer provides a separate space for storing fruits and vegetables in the fresh food compartment. Its clear plastic design makes contents easy to see, while the raised sides keep produce contained and organized. Cracks, broken edges, or damaged sliding surfaces may cause the drawer to stick or become difficult to...Read more use. Replacing a damaged drawer helps restore convenient produce storage and smooth access. Empty the old drawer before removal, and wash the new bin with mild soap and water before use. This is an OEM part sourced directly from the manufacturer.
Manage cooling and automatic defrost cycles with this refrigerator electronic control board. It processes temperature information and user settings, then directs connected components to maintain the selected cooling levels. A faulty board may cause uneven temperatures, continuous running, interrupted cooling, or frost buildup from missed ...Read moredefrost cycles. Replacing a failed board helps restore normal system control. Unplug the refrigerator before installation and handle the board by its edges. Complete setup by following the supplied programming instructions and entering the appliance program code printed on its identification label. This is an OEM part sourced directly from the manufacturer.
This is a deli drawer glide for the right side of your refrigerator. It allows the deli drawer to glide in and out smoothly. In order to access your glider, you will have to remove drawer and shelf, and unscrew the existing screws. Reverse and reinstall. This part is approximately 14.5 inches long, and made of white plastic.
This touch-up paint can be used on a wide variety of household appliances. It is most often used on washers, dryer, refrigerators, dishwashers, ranges, freezers, trash compactors, or microwaves. It is an 18 ml, or.6 fluid ounces, bottle of touch-up paint. It also features a brush for easy application. This quick-drying, long-lasting paint...Read more is perfect for fixing any nicks, scratches, or chips on the exterior of your appliance. This paint is white in color, and provides a durable finish.
This is a replacement pan glide for your refrigerator. The pan glide can be found attached to the refrigerator shelf, and allows the pan to slide in and out efficiently. If your refrigerator pan will not slide in or out of place properly, or if the pan will not stay in place, you may need to replace the glide. There is a pan glide on the ...Read moreleft and the right side of the refrigerator shelf. This part is the left side glide, so be sure to determine whether you need to replace the left glide or the right glide. This part is made of white plastic, and is approximately 15 inches long.
A warm refrigerator or noisy evaporator fan can indicate a problem with the fan blade. This white, four-blade OEM part circulates cold air over the refrigerators evaporator coils. Confirm fit using your refrigerators model number.
This long harness thermistor kit is what helps monitor and regulate the temperature inside your refrigerator. It can be located in either the freezer compartment near the evaporator coils or in the fresh food compartment near the airflow channels, depending on the model. If you notice issues like excessive icing in the freezer, inadequate...Read more cooling in the refrigerator, temperature fluctuations, or error messages on the display panel, it indicates a potential problem with the thermistor. Since your fridge will not be able to maintain the desired temperature, this results in food spoilage, inefficient cooling, and potential damage to the cooling components. To replace the thermistor, disconnect it from the connector plug or wiring harness and remove any mounting brackets or clips using a screwdriver if necessary. Remember to consult your user manual to determine the required number of thermistors, as they are sold individually as OEM replacement parts.
See how others fixed this model. Time, tools, difficulty, and steps that lead to victory!View More
Search repair tips from other customers using simple keywords like "replace", "fit", "remove", "inspect". DIY doesn't mean you have to do it alone!
Search filter:
Clear Filter
Your search term must have 3 or more characters.
Freezer is cold, Refridgerator is not as cold as it should be
385 of 474 peoplefound this instruction helpful.
Russell from Hardinsburg, KY
A Bit Difficult
More than 2 hours
Screw drivers
Having seen this problem before in other equipment so I had an idea where to look. Problem: the automatic defrost function was not operating. Looking through openings in the back panel of the freezer compartment, you could see the evaporator coils and fins were a solid chuck of ice. There are three logical components to check. Heater
... Read moreelement, thermostat (located just above the evaporator) and a relay on the control board (located in the fridge control panel). Checked the heater with an ohm meter -- OK. The thermostat closes the circuit at around 20 degrees and opens at around 32 degrees. Pulled out the thermostat, wiring, fan unit. Everything unplugs, unscrews, and unclips, don't cut wires. Put the whole assembly in a friends freezer for an hour or so to see if the thermostat closes -- OK. Problem had to be with the control board. Replaced control board, reprogrammed it per included instruction. Everything is working again.
Read less
Was this helpful?
Thank you for voting!
Cracked & Snapped Center Crisper Rail
230 of 256 peoplefound this instruction helpful.
Ruth from Roxbury, MA
Really Easy
Less than 15 mins
A very easy fix took all of five minutes
Was this helpful?
Thank you for voting!
defroster mode was not working causing freezer to ice up and refrigerator to be warm. Also fan was running continuely
189 of 228 peoplefound this instruction helpful.
James from Welches, OR
A Bit Difficult
1- 2 hours
Nutdriver, Screw drivers
The hard part for me was figuring out which part was causing the problem. I read what others had done and followed their test methods. I checked the defroster heater for continuity and the defroster thermostat to make sure it was closing. the defroster termostat has to be cold to check it. You will need to check it while it is in ice or t
... Read moreake it out and put it in another freezer for 30 mins and then check it for continuity. Those items checked out ok so it had to be the control board. The control board is a 5 min job to replace but making sure that is your problem is the hard part. I think the control board was bad due to a power surge we had when the power went out and came back on. It might be a good idea to put a surge protector on your home to protect your fridge and all your other electronic stuff. Our refrigerator is now working like new again. Thank you for all your help, Jim