Models
>
967061501
967061501 Poulan Chainsaw - Overview
Sections of the 967061501
[Viewing 3 of 3]Keep searches simple, eg. "belt" or "pump".
Bulb-Purge "snap-in"
PartSelect #: PS9471212
Manufacturer #: 530047721
This primer bulb, also known as a purge bulb, is used to push more fuel from the fuel tank into the carburetor of your small engine equipment, to help the engine start easier. Over time and through ex...
$6.21
In Stock
Fuel Line Fitting
PartSelect #: PS9469715
Manufacturer #: 530023877
The Fuel Line Fitting is a plastic part which attaches two pieces of fuel line together. If broken due to damage/fatigue, there may be a leak and the part must be replaced. Installation is rated as "E...
$4.99
In Stock
Nut - Bar Mounting
PartSelect #: PS9469166
Manufacturer #: 530015917
The OEM Mounting Bar Nut is a nut used to install a mounting bar to your machine. Installation requires a wrench set and socket set, and is rated as "Easy". This nut attaches to the chainbar studs.
$3.99
In Stock
Questions And Answers for 967061501
We're sorry, but our Q&A experts are temporarily unavailable.
Please check back later if you still haven't found the answer you need.
Common Symptoms of the 967061501
[Viewing 2 of 2]Cannot pull starter cord out or engine will not turn over
Fixed by
these parts
these parts
Show All
Will Not Start
Fixed by
these parts
these parts
Show All
Keep searches simple. Use keywords, e.g. "leaking", "pump", "broken" or "fit".
Rope pulled out and didn't retrieve
Pulled rope pull assembly housing, 4 screws and removed center screw that holds the eps plastic gear and spring was under neath that and it was bent out of shape. Important part is install new spring with yellow painted end outward , toward housing! Lucky I bought two??
Parts Used:
-
Mike from Noble, OK
-
Difficulty Level:Really Easy
-
Total Repair Time:Less than 15 mins
-
Tools:Nutdriver
4 of 5 people
found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
The saw started running too fast on idle and was over revving under light load.
I tried a few adjustment on the carb jets and the idle speed but it got worse. I opened it up and discovered that the carburetor was loose and the engine was sucking air at the carburetor mount. One of the nuts was lost so I ordered a replacement part and a spare in case it happens again. This saw has worn out at least 6 chains, three gui
... Read more
de bars and a sprocket. Had one other repair a year ago when it broke a clutch spring in the sprocket.
Read less
Parts Used:
-
Kenneth from Fremont, NE
-
Difficulty Level:Really Easy
-
Total Repair Time:30 - 60 mins
3 of 3 people
found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
Pull cord failed to retract
Removed cowling and spool. Spring drops in place without need for adjustment.
Parts Used:
-
Joel from West Roxbury, MA
-
Difficulty Level:Really Easy
-
Total Repair Time:Less than 15 mins
3 of 3 people
found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!