9550H Makita Grinder - Overview

Length 8 Foot Length: 6' Gauge: 18 Wires: 2 Type: Bare Wire This power supply cord is a genuine OEM sourced replacement part. It is specially made to supply power from a standard outlet to Makita power tools. A cracked or damaged cord should be replaced before continuing to use the tool. This rubber insulated cord is sold individ...Read moreually. It comes with a rubber sleeve grommet that is not sold separately. Replacing this power supply cord you will need a screwdriver. • Remove the housing screws • Remove the the housing • Disconnect the old cord wires • Remove the old power cord • Secure the new cord in place • Connect the wires • Reassemble and test the new cord

This #191938-1 (CB-408) Makita carbon brush set contains two individual carbon brushes with wire leads and brush springs attached. The set contains genuine Makita replacement parts, and comes packaged in a Makita retail box. This brush set will fit the Makita tools listed at the bottom of the page. • Worn brushes are often the cause...Read more of a poorly running motor • Replacing brushes can fix an intermittent motor • New brushes can restore a motor's electric braking Carbon motor brushes are one of the most commonly replaced power tool components. Because carbon brushes are wear items, meaning that through friction and use they will gradually wear away, they will eventually require replacement. Worn brushes are common causes of intermittent motor function, reduced electric braking, and reduced motor power. A worn out brush will often be worn down near the wire lead and may be cracked, pitted, or burned. When replacing carbon brushes, be sure to also inspect your armature for burns, cracks, or other damage which indicates a larger motor problem.

Genuine Manufacturer Approved replacement part designed to work with certain Makita Angle Grinders. This part is made out of Metal and it is Sold Individually. This Shoulder Pin is part of the Lock Button Assembly.

This is a genuine Makita replacement part, it is sold individually. The 233376-2 Spring is part of the spindle lock system on the Grinders shown below. The reason for locking the spindle is so that you can remove and replace grinding wheels. The other parts need for the spindle lock system are part numbers. • 417771-6 Pin cap • 256486-8 Shoulder Pin • And 256486-8 O Ring.

This is an authentic Makita replacement part manufactured for use with angle grinders and circular saws. The sealed bearing is used to reduce friction between a rotating shaft and fixed housing or assembly. This bearing is often used to allow the spindle to rotate inside the gear box, but may have other uses. Please see model diagram for part location and usage. This bearing is sold individually.

This is a genuine manufacturer-sourced part which is specially designed for Makita sanders, jig saws, and routers. This cord guard is used to protect the power cord from getting damaged. No tools are required to install the cord guard, simply slide the power cord in place through the cord guard. This part is made of rubber and is sold individually.

This is an authentic Makita manufactured for use with electric power tools. The special strain relief is commonly used to secure the power cord wires to the switch block to prevent the wires from being pulled out of the switch. This strain relief is available as an individual replacement part, please see model diagram for associative parts.

This is an authentic replacement part manufactured for use with Makita power tools. The special label is a great item to improve the look of the tool and can rejuvenate a refurbished tool. This label is available as an individual replacement part, please see model diagram for associative parts.