924056 (000101) Ariens Snow Blower - Overview

This OEM-verified shear bolt, measuring 2-1/8 inches in length and 5/16 inches in diameter, is designed to break under excessive force to protect your lawn equipment by absorbing the impact. Specifically, it allows the augers of your machine to stop while the shaft and gear case continue to rotate. To check if the shear bolt is broken, in...Read morespect it for fractures or missing pieces. You might notice that the shaft of your machine is rotating normally but the augers are not moving with it. It is important to address a damaged shear bolt promptly to avoid costly repairs or equipment failure. To remove the shear bolt from your machine, use a wrench or socket to turn it counterclockwise. As this replacement part is sold individually, it is strongly recommended that you keep spare bolts on hand in the event that they break.

The Friction Wheel is part of the clutch assembly, which helps to drive your unit. If broken from being worn down, you will have drivability problems and should replace the part. This part is metal with a rubber outer ring, and comes in white/black. Installation will require a wrench set, socket set, and pliers and is rated as "Medium" di...Read morefficulty by customers. Refer to your make, model and diagram to check if this is the right part for you.

This OEM-sourced flange bushing supports smooth movement in your lawn equipment by reducing friction. This bearing has an inner diameter of 0.625 inches, an outer diameter of 0.750 inches, a width of 0.5 inches, and a flange diameter of 0.875 inches. Depending on the model and make of your machine, this bushing can be found in various par...Read morets of your machine, such as pivot points, axles, and spindles. A damaged bushing causes increased friction, misalignment, and grinding or squeaking noises. Your machine may need expensive repairs and may eventually fail if you do not replace a broken bushing. To remove an existing bushing, you need to remove components that provide access to the flange bearing. Consult your user manual if needed. Locate the bearing and use a screwdriver or wrench to remove any clips, screws, or bolts securing it. Use a bearing puller tool or a mallet to pull or tap the bearing out of your machine if necessary. Please note that the bushing is sold individually.

This is an authentic Ariens replacement part that has been sourced from the original manufacturer to be used with snowthrowers. The metal spring is used to link the control and the idler pulley arm to allow the cable to engage the idler to drive the traction control. This item is available as an individual replacement part.

This is an OEM Ariens part directly sourced from the manufacturer for use in snowblowers. The seal attaches to the gear case and is made of metal. During replacement, it may require a socket set to help install this part correctly. It may become broken and will need to be replaced. This is available as an individual replacement part.

This is a genuine Ariens replacement part that has been sourced from the original manufacturer to be used with snowthrowers. The metal bushing fits into the bearing support to provide spacing between the rake shaft and the support. The bushing is sold as an individual replacement part.

This is an authentic OEM part. This key is made of molded plastic and metal and is designed for use with Ariens snowblowers and snow tractors. It is used to start the machine and functions as a safety feature to prevent unauthorized use. This item is sold individually.