9035DW Makita Sander - Overview

This is an Authentic OEM replacement part designed for use with Makita Finishing Sanders. It acts as a support. This part is made out of Plastic with Two (2) Metal Fittings that help to secure it. Includes One (1) Foot per order. You would need a Screwdriver and Pliers to complete the job. • Remove the Sander Pad and a Plate by remov...Read moreing 4 pad mounting screws • Remove the dust vacuum housing by removing 2 screws • Remove flywheel from motor shaft by removing one screw from the motor shaft • Disassemble the main body by removing 4 body screws • Make sure to clean the sander interior • Remove and replace broken foot by sliding it out of the mounting slot • Reassemble the sander

It is a genuine manufacturer-approved replacement switch which is specially designed for use with Makita equipment. It is the part of the tool handling on/off operations, over time it may wear out and begin to fail eventually requiring a replacement. Keep in mind this high-quality item is made of durable plastic material and is sold individually.

This manufacturer sourced replacement pin is made out rubber and it is sold individually. It acts as a cushion/spacer in a variety of Makita power tools. This is a standard piece of hardware and it has multiple applications based on your tool. Please refer to diagrams for correct application.

Genuine Makita replacement part, this item is sold individually. This screw is used on a variety of Makita tools. Use Phillips Head Screwdriver to tighten and loosen this screw. Follow appropriate safety practices when installing screw.

The battery holder attaches to the main frame. This part is made of metal and plastic and is available individually. It is a genuine replacement part sourced from the original manufacturer for use with blowers, saws, drills, trimmers, planers, sanders, shears, staplers, and vacuums made by Makita and DeWALT. When replacing this item a set...Read more of pliers might be required during the installation process. It will require replacing if it becomes broken.

This is a genuine OEM sourced replacement screw. It is specially produced for use in Makita power tools. It has multiple uses depending on the tool. Please make sure to check your equipments diagrams for correct location and applications of this hardware. One pan head screw is included per order. You will need a phillips screwdriver to install or remove this screw.

Genuine Makita replacement part. This pan-head phillips screw includes a washer. It is sold individually.