9000 - Overview

This tune-up kit is a genuine OEM replacement kit used in lawn and garden equipment. It is specially designed to provide you with everything you need to maintain your engine in one easy package. The kit includes one air filter, one spark plug, and one fuel filter. The air filter prevents contaminants in the air from flowing into the equip...Read morement engine. The fuel filter prevents contaminants from entering the fuel tank, and the spark plug is responsible for igniting the fuel and air mixture that allows the engine to run. It is normal for the filters to wear down or become clogged with debris over time while the spark plug can become fouled or damaged as well. If these parts are faulty, you will have difficulties starting your equipment, your engine may overheat and stall, and you will notice reduced power output from your equipment. It is recommended to replace these parts at the beginning of each season for optimal performance. Detach the air filter cover and clean the housing before placing the new air filter in place. Drain the fuel from the tank, disconnect the fuel lines, and replace the fuel filter. Finally, use a spark plug wrench to remove the faulty spark plug, and use a gaping tool to set the correct gap size on your new spark plug according to your model specifications. Thread the new spark plug in by hand and then tighten it with the wrench to complete your repair.

This OEM Wheel Shaft Oil Seal is a black rubber part which attaches to the drive shaft to prevent leaks between the wheel shaft and transmission case. Installation is rated as "Medium" difficulty and requires a Screwdriver, Hammer, Washer, and Pipe to fit in the seal. If broken due to damage/fatigue, there will be a leak and the part shou...Read moreld be replaced. Refer to your make, model, and diagrams to ensure this is the right part for you.

This is an authentic Troy-Bilt replacement part that has been sourced from the original manufacturer to be used with tillers. The knob attaches to the end of the depth regulator bar and is used to provide a grip to the bar when changing the depth of cut. This item is available as an individual replacement part.

This is a genuine manufacturer-sourced component which is specially made for use with Troy-Bilt tillers. It is an identical replacement for a missing or a faulty bolo tine that was installed on a new unit. Soil conditions are important for proper tilling. Tines will not readily penetrate dry, hard soil which may contribute to excessive bo...Read moreunce and difficult handling of your tiller. Please make sure to refer to the owner's manual and the appropriate diagrams of your model for the correct location and application of this part. Keep in mind this high-quality tine is made of durable metal and is sold individually.

This is a genuine Craftsman replacement part that is sourced from the original manufacturer to be used with snowthrowers. The metal hex nut is commonly used to fasten the bolt that secures the height skid to the auger housing. This item is available as an individual replacement part, please note four nuts may be required.

An authentic item that is supplied directly from the original equipment manufacturer for use with Troy-Bilt tillers. It is a special gasket that helps to provide a tight seal for the front bearing cap, over time the material may wear out and begin to crack eventually requiring a replacement. Keep in mind this high-quality part is made of durable composite material and is sold individually.