8924 - Overview

This flat washer is an OEM part that is silver in color, made of metal, and its job in your equipment is to spread load and pressure under a bolt. It can have multiple uses depending on your equipment, and can be used in a lot of different equipment, so be sure to consult your owners manual or check your part number to ensure this fits yo...Read moreur model. Over time the washer may become damaged; watch for cupping from over-tightening as a leading cause. This is a very easy part to repair and does not require any tools.

This is an authentic Murray replacement part that has been sourced from the original manufacturer to be used with riding lawnmowers. The metal washer is used to provide spacing between the steering spindle and the front axle assembly. This item is sold individually, please note two washers may be needed.

The drive belt wraps around the spindle pulley and is available as an individual replacement part. This is an original Snapper part designed for rear engine rider mowers. The belt will need to be replaced if it becomes stretched or broken. During installation, a wrench may be needed to replace this item.

It is a genuine item that is supplied directly from the original equipment manufacturer for use with Briggs and Stratton generators and pressure washers. The purpose of this component is to reduce the vibration of a working unit, unfortunately, over time it may begin to fail eventually requiring a replacement. Please make sure to refer to...Read more the appropriate diagrams of your model for the correct location and application of this part. Keep in mind this high-quality vibe mount with a washer is sold individually.

The battery charge rectifier goes inside the control box. It is an OEM from Briggs & Stratton for use in generators. This part is sold individually and is made of metal. A wrench and a screwdriver may be required to replace this part. It will need to be replaced if it breaks.

This is available as an individual replacement. The outlet is part of the control panel assembly. When replacing this item a wrench may be needed. It is made of metal and plastic and will need to be replaced if it becomes broken. This is an authentic Briggs & Stratton and Snapper replacement part that is sourced from the original manufacturer for use with generators.

This item is available as an individual replacement part. The outlet is made out of metal and plastic. It may require a wrench during installation. This item will need to be replaced if it breaks. It is a replacement part directly sourced from the manufacturer for use in generators made by Briggs & Stratton and Snapper.

The pinion gear attaches to the height adjuster. It is a genuine item that is supplied by the original equipment manufacturer for use with Briggs & Stratton generators and Murray lawn mowers. This part is made of metal and is sold individually. A wrench and set of pliers may be helpful when replacing this part. It will need to be replaced if it breaks or becomes stripped.

This is an authentic replacement part, sourced from the original manufacturer for use with riding lawnmowers from Snapper and Murray. The durable plastic discharge chute connects to the side of the mower's deck and is used to guide grass clippings as they are discharged from the deck. This item is available as an individual replacement part.

This is a manufacturer-approved part which is specially designed for Murray and Briggs and Stratton lawn and garden equipment. Bearings are generally utilized to provide a tight fit between connected components while allowing for movement with minimum friction. If the part is worn, damaged or is missing, this will provide an identical rep...Read morelacement for the original hardware that was installed on a new unit. Note, one durable metal bearing is included. Refer to the appropriate diagrams for your model to ensure the proper repair procedure. A wrench set will be needed to replace this component.

This is an OEM part sourced directly from the manufacturer. The brush is designed for use in generators from Briggs & Stratton. This part is a complete carbon brush assembly, which is used to supply power to the rotor. You may require a screwdriver or Allen wrench when replacing this part. This item is sold individually.