8856 - Overview

This hex nut is a fastener made from steel and is used to secure the end of a bolt in various lawn and garden equipment and machinery. It is a genuine OEM replacement part that comes in a standard size of 5/16 of an inch with 18 threads per inch. The hex nut has a hexagonal shape, which gives it greater grip and makes it easy to tighten u...Read moresing a wrench or a set of pliers. The nut also has a flange on one end, which locks the nut in place, prevents damage to the area where it is installed, and allows the load to be evenly distributed. It is important to replace your hex nut if it is loose, cracked, or corroded. If you have not yet removed the old hex nut from your equipment you will need a socket wrench to remove it. After that, you can easily install the new nut by threading it onto a bolt or screw and then tightening it with a wrench or pliers until it is tightly secured.

The hair pin is a silver, metal pin used to secure and lock parts in place. If broken, the part being secured will come loose and the pin should be replaced. This is an OEM part directly from the manufacturer. Most customers rated the replacement of the hair pin as an easy repair.

This is a genuine Broil-Mate, Broil King, Huntington, and Sterling part sourced directly from the manufacturer for use in gas grills. The grease shield goes next to the inner rear panel. A wrench and a screwdriver may be necessary during the installation of this item. It may become broken and will need to be replaced. This is made of metal and is available as an individual replacement part.

This 5/8 Washer is an OEM part that spreads load under a bolt or nut in a variety of different lawn equipment. This washer has an inside diameter of 0.625 inches, or 5/8. It is silver in color, made of metal, and sold individually. Over time, the washer may become damaged due to fatigue, and need to be replaced. Depending on the locatio...Read moren of the bolt or nut it is associated with, this repair may vary in difficulty, but generally it should be easy and not require any special tools.

BOLT, 5/16-18 x 3/4" Short Neck Carriage, GR 5

This flange nut is designed for use in lawn and garden equipment. It is an OEM replacement part with a diameter of 0.375 inches and a thread pitch of 16 threads per inch. The nut has a ring-shaped extension on one end, known as a flange which helps to evenly distribute the clamping force of the nut and provide a more secure hold. Addition...Read moreally, the flange eliminates the need for separate washers and reduces the risk of abrasion on the surface being fastened. It is normal for the nut to corrode, crack, or for the threads to wear down over time. To replace the flange nut, unthread it from the fastener, and insert and secure the new one using a socket/wrench. Each sold individually.

This is a genuine replacement part sourced directly from the manufacturer. The pin is commonly found in Murray lawn tractors. This part is made of metal, and may be found in various locations in the machine, depending on model. Please refer to the parts diagram to be sure of ordering the correct part. You may require pliers and a wrench when replacing this item. The pin is sold as an individual replacement part.

This is an OEM part sourced directly from the manufacturer. The spring is designed for use in grills from Broil King, Broil-Mate, Huntington, and Sterling. This part is made of metal, and is placed to provide tension to the control cover. You may require a screwdriver when replacing this part. This item is sold individually.

This is an authentic OEM sourced replacement part designed for use with Weber grills. These rails are used to hold the grease/drip funnel tray to the underside of the grill so you can slide the tray in and out for easy cleaning. This set includes two (2) aluminum bottom tray rails with four (4) screws used to mount rails. To complete this repair you will need a screwdriver.