8806-1 Bissell Carpet Cleaner - Overview

This authentic OEM retainer assembly secures the left and right pivot arms of the brush roll assembly on your steam vacuum. The pivot arms allow the brushes to move and adjust to various surfaces for effective cleaning, and the retainer assembly ensures they stay in place during operation. The assembly comes with the necessary hardware fo...Read morer replacement and is typically located on the sides of the front base, beneath the plastic base window. If you notice that the pivot arms are loose or worn out, it is time to replace the assembly. To remove it, refer to your user manual to locate and access it at the base of your vacuum. Unthread the mounting screws and remove the old assembly from its housing, then proceed with installing the new assembly. Please remember that this includes both the left and right pivot arm retainers along with the necessary fasteners for installation.

These are the right and left elevator levers for a variety of vacuum models. These levers are responsible for adjusting the height of the vacuum and its brush to suit different floor types, levels, and cleaning requirements. Crafted from high-quality OEM plastic, this pair of levers is sold individually and includes two levers and necessa...Read morery springs. As these levers are made of plastic, they can break under excessive stress, use, or when clogged with dirt and debris. If broken, noticeable signs include difficulty in raising or lowering the vacuum, being stuck in place, or failure to pick up dirt effectively. To replace these levers, a Philips-head and flat-head screwdriver are all that is needed. Begin by carefully disassembling your vacuum, unscrewing the screws around the chassis, and removing the top to access its interior. Once the top portion is removed, unscrew and remove the motor cover or any obstructing part that blocks access to the lever(s). If necessary, remove the carry handle and/or brush roll to access the levers. The levers are located on each side of the vacuum interior and can be carefully removed by prying them out with a flathead screwdriver. Replace the levers, then reassemble the top portion, carry handle, and brush roll of the vacuum.

Genuine Bissell replacement part,this item is sold individually. This belt is driven by the motor to operate the Pump Assembly for the models listed below. Overtime the Belt will wear and stretch, causing the pump to not work properly. It is advised to get an extra belt to keep on hand.

This is an authentic Bissel replacement part manufactured for use with carpet cleaners. This rubber seal is used to form a seal were the base widow connects to the main housing. The oval window seal is sold individually.

This is an authentic Bissell replacement part that is OEM sourced to ensure a high-level of quality. The pump is intended to be used with carpet cleaners. If your carpet cleaner is not pumping out cleaner solution the pump may need to be replaced. The pump is priced as a single item.