8804M Bissell Carpet Cleaner - Overview

This authentic OEM retainer assembly secures the left and right pivot arms of the brush roll assembly on your steam vacuum. The pivot arms allow the brushes to move and adjust to various surfaces for effective cleaning, and the retainer assembly ensures they stay in place during operation. The assembly comes with the necessary hardware fo...Read morer replacement and is typically located on the sides of the front base, beneath the plastic base window. If you notice that the pivot arms are loose or worn out, it is time to replace the assembly. To remove it, refer to your user manual to locate and access it at the base of your vacuum. Unthread the mounting screws and remove the old assembly from its housing, then proceed with installing the new assembly. Please remember that this includes both the left and right pivot arm retainers along with the necessary fasteners for installation.

Genuine Bissell replacement part, this part is geared and is also sold individually. This is the belt that connects to the end of the B-010-7185 Pump Assembly, which is run by the motor to rotate the Brush assembly. It is compatible with the models shown below.

These are the right and left elevator levers for a variety of vacuum models. These levers are responsible for adjusting the height of the vacuum and its brush to suit different floor types, levels, and cleaning requirements. Crafted from high-quality OEM plastic, this pair of levers is sold individually and includes two levers and necessa...Read morery springs. As these levers are made of plastic, they can break under excessive stress, use, or when clogged with dirt and debris. If broken, noticeable signs include difficulty in raising or lowering the vacuum, being stuck in place, or failure to pick up dirt effectively. To replace these levers, a Philips-head and flat-head screwdriver are all that is needed. Begin by carefully disassembling your vacuum, unscrewing the screws around the chassis, and removing the top to access its interior. Once the top portion is removed, unscrew and remove the motor cover or any obstructing part that blocks access to the lever(s). If necessary, remove the carry handle and/or brush roll to access the levers. The levers are located on each side of the vacuum interior and can be carefully removed by prying them out with a flathead screwdriver. Replace the levers, then reassemble the top portion, carry handle, and brush roll of the vacuum.

This high quality automix assembly is supplied from original equipment manufacturer for Bissell carpet cleaners. Its purpose is to mix the cleaning solution and the water in a correct ratio. The ratio can be adjusted by turning the knob which is sold separately. Over time the part may get clogged eventually requiring replacement. When rep...Read morelacing this automix assembly it is advised that you also replace the piston to maintain peak performance. Please note one durable plastic part is included per order.

Genuine Bissell replacement part,this item is sold individually. This belt is driven by the motor to operate the Pump Assembly for the models listed below. Overtime the Belt will wear and stretch, causing the pump to not work properly. It is advised to get an extra belt to keep on hand.

This authentic item is supplied directly from the original equipment manufacturer for use with Bissell carpet cleaners. The purpose of a turbo brush is to assist in picking up materials from a floor. It is an identical replacement for a missing or damaged turbo brush that was originally included with a new unit. Keep in mind this high-quality component is made of durable plastic materials and is sold individually.

This replacement shampoo bottle assembly is an authentic OEM sourced item that is specially designed for Bissell carpet cleaners. It is a high quality item that is used to hold the shampoo needed for the unit. Please note this assembly includes the durable plastic item and the cap with an insert.

It is a genuine replacement part that is supplied directly from original equipment manufacturer for use with Bissell carpet cleaners. This is the cap that will keep the shampoo inside the bottle assembly. It a complete assembly which includes one plastic cap and one flexible hose per order.