This is a genuine replacement part that has been OEM sourced. The v-belt is intended to be used with snowthrowers from Lawn Boy. The v-belt is used to link the crankshaft pulley and the main pulley that drives the transmission and the auger. This item is available as an individual replacement part.
See how others fixed this model. Time, tools, difficulty, and steps that lead to victory!View More
Search repair tips from other customers using simple keywords like "replace", "fit", "remove", "inspect". DIY doesn't mean you have to do it alone!
Search filter:
Clear Filter
Your search term must have 3 or more characters.
Toggle switch to operate exhaust fan and oven light inop.
26 of 31 peoplefound this instruction helpful.
T from Southfield, MI
Really Easy
15 - 30 mins
Screw drivers
First I turned off electrical power to the range by turning off the circuit breaker for the range. Then I removed the two screws that hold the switch plate to top of front of range. Then I pushed the sw plate back toward to rear of range to disengage it from the guide pin, and lifted the switch plate and switch. Turned the switch p
... Read morelate over and labelled the four wires to the switch. Removed the wire which were push-on. Which allowed me to remove the switch plate completely from the range. At my bench I used my Dremell with a cutting wheel to cut off the two push nuts/washers holding the switch to the switch plate. Removed the old switch and replaced it with the new one. Pushed to the new push nuts/washers provided in the kit, and re-assempled.
Read less
Was this helpful?
Thank you for voting!
fan/light switch broke
4 of 5 peoplefound this instruction helpful.
Michael from Westford, MA
Really Easy
15 - 30 mins
Pliers, Screw drivers
- the fan/light switch was still functioning, but it fell into the cavity underneath, after years of use, heat and grease caused it to weaken. - 4 wires came off the old switch, and went on the new one with ease. - the only complication was in getting the clips off of the old ones, and getting the new clips onto the new one. oth
... Read moreerwise, a piece of cake.
Read less
Was this helpful?
Thank you for voting!
toggle switch for fan/light had melted from a hot pan placed on it (presumed)
3 of 4 peoplefound this instruction helpful.
Shirley from Columbus, OH
Easy
30 - 60 mins
Pliers, Screw drivers
Installing the new switch was EASY. However, removing the old switch was very difficult due to the nuts holding the switch in place being designed as clamps not threaded screws and nuts.