EasyApplianceParts is now PartSelect! We've merged our sites to provide a better shopping experience for you.   Full Details
✖

Find Parts

Parts Departments

Top Model Types

Top Brands

Repair Help

Expert Repair Videos

Keep typing for more specific results...

867811050 Kenmore Air Conditioner - Overview

Diagrams for 867811050

See every part. Know exactly what you need.

Enter a part description. DIY Heroes keep it simple, eg. "belt" or "pump".

Search filter:
Clear Filter
Your search term must have 3 or more characters.
Washer Screw – Part Number: WP273556
$7.47
In Stock
Washer Screw
Part #WP273556
Sold individually.
Front grille – Part Number: 710563
No Longer Available
Front grille
Part #710563
EVAPORATOR – Part Number: 92637
$617.95
Special Order
EVAPORATOR
Part #92637
DISCONTINUED – Part Number: 4147477
No Longer Available
DISCONTINUED
Part #4147477
TIMER ASSEMBLY – Part Number: 700529
No Longer Available
TIMER ASSEMBLY
Part #700529
Thread-cutting screw, 8-pack – Part Number: 448435
No Longer Available
Clamp cap – Part Number: 706440
No Longer Available
Clamp cap
Part #706440
Support – Part Number: 710525
No Longer Available
Support
Part #710525
Support – Part Number: 85400
No Longer Available
Support
Part #85400
Cover plate – Part Number: 85812
No Longer Available
Cover plate
Part #85812
Cage nut – Part Number: 86028
No Longer Available
Cage nut
Part #86028
Screw – Part Number: 451188
No Longer Available
Screw
Part #451188
See how others fixed this model. Time, tools, difficulty, and steps that lead to victory! View More

Search repair tips from other customers using simple keywords like "replace", "fit", "remove", "inspect". DIY doesn't mean you have to do it alone!

Search filter:
Clear Filter
Your search term must have 3 or more characters.
Washer wouldn’t drain and spin
3 of 3 people found this instruction helpful.
  • Thomas from KENT, CT
  • Very Easy
  • Less than 15 mins
  • Pliers, Screw drivers
First used wet vac to get water out. Unplug electrical cord. Shut off water and unhook lines. Unhook drain tube. Flip over on side. Take belt cover off. two screws.
Took photos of parts removing just for re- install. Ordered parts from part select.com. Came in Two days. The dealer was on 12 days I gave up on them. I re moved actuator two easy screws and pulled off electrical connection no tool needed. Then removed pump three longer screws Than other part. Make sure to label them in a ziplock baggie. Plus I removed hose clamp with pliers slide Back on hose and pull hose off. Then remove electrical connection on pump. If it makes you feel better label each with masking tape so I know where each connection goes. Then replace pump first with new one. Make sure you push it in hard then the screws. Don’t over tighten. Plastic parts break. Hook back up hose slide clamp back over fitting end with pliers. Hook up wire connector. Next hook up actuator. Two screws wire connector and your done. Put belt guard back on. Socks can get caught under washer get in belt and cause major issue. Then you need to reconnect water lines. Make sure hot goes to hot. Cold to cold. Drain hose hook back up. Plug in power cord. Now the fun part. Run a diagnostic and then calibration. See you tube videos it’s like 3 clicks to left then two to right with selector knob. Write down the exact amount of clicks and steps. It works. Be sure to turn knob 4 times to left to clear it like a combination lock. Don’t let the noises scare you it makes all
Kinds of sounds while calibration goes on.
Was this helpful?
Thank you for voting!