8647 - Overview

This is a genuine replacement pre-cleaner filter used with Briggs and Stratton engines. It is supplied directly from original equipment manufacturer. Its purpose is to filter out dust and debris from contaminating the engine. This filter is made out of paper and metal. This item is sold individually. Replacing this filter is a simple that that would only require a wrench.

This item has been sourced from the original manufacturer and is intended to be used with snowthrowers from Snapper. This scraper blade attaches to the bottom of the auger housing. This item is used to guard the housing by scraping snow into the auger blades. The scraper blade is sold as an individual replacement part.

This flat washer is an OEM part that is silver in color, made of metal, and its job in your equipment is to spread load and pressure under a bolt. It can have multiple uses depending on your equipment, and can be used in a lot of different equipment, so be sure to consult your owners manual or check your part number to ensure this fits yo...Read moreur model. Over time the washer may become damaged; watch for cupping from over-tightening as a leading cause. This is a very easy part to repair and does not require any tools.

Gear worm

This manufacturer approved replacement part is specially produced for use with Briggs and Stratton engines commonly installed on Toro lawn and garden equipment. It is utilized to keep the oil in the tank. Please note this durable plastic oil fill cap is sold individually.

This paper air cleaner element, also known as an air filter, is sourced from the original manufacturer for use in outdoor power equipment. It has an outer diameter of 4.25 inches and a height of 3 inches. The air filter is responsible for removing dirt and debris from the air before it enters the engine to keep the engine free from contam...Read moreinants. Over time, it is normal for the paper on the filter to tear or become clogged, thereby restricting airflow, increasing fuel consumption, and damaging the engine. Regularly inspecting and replacing the air filter is critical to maintaining the performance of your engine. To begin this repair, locate the air filter housing near the engine or carburetor and remove the cover. Carefully remove and discard the old filter, making note of its position. Clean the air filter housing and insert a new, clean filter in the correct position. Place the cover back onto the housing and ensure that it is tightly fitted to prevent air leaks.

This is an authentic Murray replacement part that has been sourced from the original manufacturer to be used with riding lawnmowers. The metal washer is used to provide spacing between the steering spindle and the front axle assembly. This item is sold individually, please note two washers may be needed.

This is a genuine OEM sourced part which is specially made for use with a variety of lawn and garden equipment. A spark plug delivers electric current from the ignition system to the internal combustion engine. Unfortunately, over time spark plugs will become dirty or fouled eventually requiring a replacement to maintain peak performance....Read more Note, you should gap your spark plug according to the owners manual of the outdoor product you have. Keep in mind this high-quality spark plug is made of durable materials and is sold individually.

This is an OEM part sourced directly from the manufacturer. The brush is designed for use in generators from Briggs & Stratton. This part is a complete carbon brush assembly, which is used to supply power to the rotor. You may require a screwdriver or Allen wrench when replacing this part. This item is sold individually.

This connector is sourced from the original manufacturer as a replacement part for use in generators. The connector has 6 pins/terminals which allow the joining of various electrical cables and components in the generator. Over time the connector can break or wear down, rendering it unable to secure components together. This can result in...Read more electrical hazards, overheating, instability, and loose connections. Disconnect the wires/cables connected to the old connector and remove it from the housing. Place the new connector in the housing and reconnect the wires to the appropriate terminals, following the guidelines in your equipment manual.