8519 Roper Dishwasher - Overview

Metallic screw that is less than an inch long. Does not include the plastic washer.

The hose clamp is used to hold the water hose in place which will prevent the hose from leaking water. Sometimes the clamp may lose its ability to latch on, causing a leaking washer. For the installation, you will need a flat head screw driver to replace the clamp and a drill to access the screws to remove the front of the washer. Be care...Read moreful if you do not have specific clamp pliers as the clamp could fly off. Once the front of the washer has been removed, take a quick look for water damage or any obvious signs of where the leak is coming from. If it is not obvious, run water to test.

This screw is sold individually.

Sold individually.

This is a 12oz (about 355 ml) can of black spray paint that is compatible with a variety of different home appliances and is used to cover and conceal any visible scuffs, scratches or chips. This can is sold individually, so consider how much paint you need for your appliances prior to placing an order. To use this spray paint, make sure ...Read moreto have the proper personal protective equipment, such as protective glasses or gloves, as well as a respirator. Clean the surface of whatever you are spraying before you begin and shake the can for 1 minute after hearing the internal mixing balls rattle. Do not spray during high heat or humidity, spray at room temperature and in several thin coats to ensure the best adherence.

Sold individually.

A zip tie, also known as a cable tie or a wire tie, is a fastening device that holds wires or tubing together. If a machine has wires or tubing that are easily shifted, you need to hold them tightly together using a zip tie. It is a flexible, plastic strip that has serrated teeth and a locking mechanism. If the zip tie is damaged, it shou...Read moreld be replaced. Freely moving wires may rub against surfaces, causing them to break over time. Zip ties are single-use and may not be reused after they are removed from a machine. To release the locking mechanism, you will need to insert a small flat tool into the head of the zip tie, between the tongue and the serration, and depress the bar. You can then pull the teeth out of the mechanism to loosen the cable tie. This part is produced by the original equipment manufacturer and is sold individually.

Sold individually.

These rack tine tips include 125 per pkg. Apply tips with adhesive.