84G9 Bissell Upright Vacuum - Overview

Genuine Bissell replacement belts used on Vacuums. This is the Pack of Two (2) belts. Belts tend to stretch over time, so it is recommended to change them at least every 6 months for optimum performance.

Genuine Bissell replacement part, this item is sold individually. This Filter is a Pre-Filter, which means it will pick larger debris that the Vacuums pick up before it enters the main Filter. The main Filter will pick up the smaller particles and debris. The B-203-1192 Foam Filter can be washed with water and then left to dry before using it again. Do not use soap when washing this Filter, use water only.

This high quality replacement exhaust HEPA filter is specially designed for Bissell vacuums. It is an authentic OEM sourced item, not an aftermarket imitation. Its purpose is to remove dust and other contaminants from the air that exits the unit. Please note, this pleated paper filter is sold individually. No tools needed to replace thi...Read mores filter. • Remove the filter grille • Take out the old filter • Secure the new filter in place • Reattach the grille

This part comes directly from Bissell. The Crevice Tool is used with many models of Bissell vacuums. The Crevice Tool is made of a dense plastic and is used to vacuum out all the hard to reach places where space is limited. This tool is great for corners, folds, and cracks. No tools are needed to attach this tool to the hose. This part sh...Read moreould be replaced if the tip becomes cracked or there is a clog that can't be removed.

This genuine manufacturer approved replacement part is designed for use with Bissell vacuums. This brush is a perfect attachment for picking up dust and debris. Bristles allow user to swipe up dust with ease. It is made out of plastic and it is sold individually. No tools are needed to replace it, simply slide it over the extension wand.

This part comes directly from the manufacturer. The Lever Filter is used in many models of Bissell vacuum cleaners. This Filter fits into Lock N Seal Lever (part number B-203-1190) and is used to filter out any large particles before the motor. This Filter is made of a flexible foam. This Filter should be replaced if it becomes torn or lo...Read morest. To replace this part the Dirt Cup (B-203-2453) and the Filter Case (B-203-2454) will need to be removed.

This is a genuine OEM sourced replacement part used on Bissell vacuums. Its purpose is to filter out dust and debris. This filter is made out of pleated paper and plastic. This item is sold individually. Please note the foam filter is sold separately. No tools needed to replace this filter, simply take out the old filter and replace it with a new one.

This is an OEM part sourced directly from the manufacturer. The screw is commonly found on Bissell upright vacuums. This is a metal part, commonly used to attach the hose cuff to the handle. Please be aware that there may be different screws used in the machine. You will require a screwdriver when replacing this item. This part is sold individually.

The rocker switch is made out of plastic and metal. It is available as an individual replacement part. This authentic item is supplied directly from the original equipment manufacturer for use with Bissell vacuums. A screwdriver might be helpful during the installation of this part. It will require replacing if it breaks.

This is an authentic original Bissel part manufactured for use with bagless vacuums. The plastic cyclone assembly sits inside the dirt cup, and allows air into the dirt cup in a spinning motion, please note the cyclone assembly is sold individually.

This is an authentic Bissell replacement part manufactured for use with upright vacuums. The special light bulb is used at the top of the brush roll assembly and is used to illuminate the area just in front of the vacuum. This light bulb is available as an individual replacement part, please see model diagram for associative parts.