82DN-1K Magic Chef Range - Overview
Sections of the 82DN-1K
[Viewing 1 of 1]
Keep searches simple, eg. "belt" or "pump".
Safety Valve - just over four inches long
PartSelect #: PS11744552
Manufacturer #: WP7501P133-60
This safety valve ensures that no gas is released until the igniter has received the proper voltage needed to ignite the gas range. This safety valve has an amperage range of 3.3 to 3.6 amps. The valv...
No Longer Available
Surface Burners Spark Module Kit
PartSelect #: PS2011188
Manufacturer #: 1430322
This part sends enough current to the igniter to create a spark to the bottom of the burner cap.
No Longer Available
Burner Spark Ignition Switch
PartSelect #: PS11744485
Manufacturer #: WP7403P190-60
Sold individually.
$65.73
In Stock
Control Knob - Black/Stainless
PartSelect #: PS11744664
Manufacturer #: WP7711P148-60
Sold individually. This knob accepts a D-shaped shaft.
No Longer Available
Common Symptoms of the 82DN-1K
[Viewing 2 of 2]Gas igniter glows, but will not light
Fixed by
these parts
these parts
Show All
Will Not Start
Fixed by
these parts
these parts
Show All
Keep searches simple. Use keywords, e.g. "leaking", "pump", "broken" or "fit".
the oven igniter would glow but the gas wouldn't turn on
After removing the oven door, floor, and gas-jet diffuser plate, I could see the valve. There was a shield ov er the elec connections, which I removed. I turned off the gas line to the oven and elec power from the wall, then disconnected the valve. The orig valve had a mounting bracket which I swapped to the new valve( the holes lined up
... Read more
perfectly). I bolted everything back in place, turned it on, and the oven fired right up. I was afraid an appliance this old (1984) would no longer have any parts-availability. but PartSelect came through!
Read less
Parts Used:
-
peter from marine city, MI
-
Difficulty Level:Really Easy
-
Total Repair Time:15 - 30 mins
-
Tools:Pliers, Screw drivers
16 of 20 people
found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
gas burners and gas oven would not light
unplug the oven and pull it away from the wall. looking at the oven from the back, the spark module is at the bottom on the lower left. there is a two piece sheetmetal cover over the area of the spark module. use a phillips head screwdriver to remove five screws and the covers come off. the spark module is the blue cube with four push
... Read more
on wire connectors. all you have to do is hold the new one next to the old one and swap one wire at a time. both were clearly marked with identical numbers and letters. really nothing to it. it took me longer to clean the back of the oven than to replace the module. the old module was eaton part number Y-54052-3. the new one is eaton part number Y-054052-34.
Read less
Parts Used:
-
nicholas from livermore, CA
-
Difficulty Level:Really Easy
-
Total Repair Time:30 - 60 mins
-
Tools:Screw drivers
14 of 22 people
found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
Oven would not lite
With a little adjustment to the mount the part went in ok. Checked the oven works like new; well better than new.
Parts Used:
-
Timothy from Petaluma, CA
-
Difficulty Level:Easy
-
Total Repair Time:1- 2 hours
-
Tools:Pliers, Screw drivers
11 of 14 people
found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!