824-163 MTD Log Splitter - Overview

This silver metal lock washer helps prevent the nut on the drive belt pulley shaft from backing off during operation, it has a 5/16-inch inner diameter and a 1/2-inch outer diameter. one washer is included, replace it if fatigue or damage allows the connected shafts to spin freely, verify fit using the equipment model or owner manual

This gray metal adjustable gib fits between two shafts and locks them together so they turn as one. It is 2 inches long and sold individually. Replace it if one shaft spins freely without turning the drive shaft. Turn off the machine and disconnect power before repair. Check the model number before ordering.

The air valve attaches to the wheel and is made of a durable material. This is a genuine MTD, Ryobi, Yard Machines, Bolens, Troy-Bilt, and Yard Man part sourced directly from the manufacturer for use in chippers, shredders, cultivators, edgers, lawn tractors, snowblowers, and trimmers. Keep in mind that this part is sold individually. Whe...Read moren replacing this item a set of pliers might be required during the installation process. It might wear out over time and will need replacing.

This OEM Hub Cap, or Dust Cap, is a 2-inch, silver, steel part, sold individually. It requires a Rubber Mallet to install and its installation is rated as Easy by our customers. This part attaches inside the wheel on the hub, and is used to keep dirt out of the hub. It must be replaced when damaged or missing (if it is damaged it will b...Read moree out of round, and will not fit). Check your model number to ensure you are purchasing the correct part.

It is an authentic manufacturer-supplied replacement part that is specially made for use with MTD log chippers. The spacer is generally utilized to separate two connected components while ensuring a tight fit, please make sure to refer to the appropriate diagrams of your model for the correct location and application of this hardware. Kee...Read morep in mind this high-quality item is made of durable metal and is sold individually.

It is a genuine item which is supplied directly from the original equipment manufacturer for use with Yard Machines and MTD lawn mowers and garden tractors. This is an identical replacement for a missing or faulty screw which was installed on a new unit, please make sure to refer to the appropriate diagrams of your model for the correct l...Read moreocation and application of this hardware. Keep in mind this durable part is made of high-quality metal and is sold individually.

This is an authentic replacement part, sourced from the original manufacturer for use with hydraulic log splitters. The metal nipple pipe is commonly used to link the hydraulic cylinder and the control valve. This nipple pipe is available as an individual replacement part, please see model diagram for associative parts.

This is a genuine replacement part sourced from the original manufacturer for use with log splitters. The metal hex cap screw is commonly used to secure the wedge assembly to the beam assembly. The hex cap screw is sold as an individual replacement part, please note six screws may be required.