8057 - Overview

The run capacitor helps the compressor kick on and off while maintaining a constant temperature in your fridge and freezer. You may need to replace your run capacitor if your refrigerator or freezer section will not start, if they are too warm, or if your refrigerator has become too noisy. Replacing the run capacitor is a relatively easy ...Read moreproject. For this repair you will only need a 1/4 inch nut driver and needle nose pliers. Remember to disconnect the power and water supply line to the unit before you begin this repair. For full step by step instructions, simply click on the video below.

Sold individually.

This is a plastic OEM drain plug that is attached to the drain system of your appliance and is compatible with several different makes and models of refrigerators, freezers, and air conditioners. This drain plug is used to prevent water from leaking out of the incorrect drain system within the appliance and is normally removed for cleanin...Read moreg and maintenance. If you notice water leaking inside of your appliance, the plug may be improperly positioned or may need replacing. To replace, simply pull off the damaged plug and insert the new plug in its place.

This OEM drain plug in your freezer is a small white circular part located at the bottom. Its purpose is to seal the front hole of the cabinet, which is used to drain water during defrosting. If you notice water leaking or pooling at the bottom, your drain plug may be deformed or broken. Failure to replace the broken plug can result in wa...Read moreter accumulation, ice buildup, and the growth of bacteria or mold. To remove the existing drain plug from your appliance, no tools are needed. You can simply pull it out of its slot. Please keep in mind that this plug is sold individually.

This part helps maintain the desired temperature.

Sold individually.

The Cotter Pin (or Split Pin) is a 2x22mm silver metal part, sold individually. It is rated as "Easy" to install, and installation will require a set of pliers. It can be attached in various locations on a variety of equipment and is used to secure and lock parts in place. If broken, damaged, or worn down the part it is securing may becom...Read moree loose, and the part should be replaced. If this part is removed for repairs, replace it with a new one. Refer to your make, model, and diagrams to make sure this is the correct part.

This is a genuine manufacturer-sourced part which is designed for use on lawn and garden equipment. It is an identical replacement for a missing or a damaged clamp that is used to secure the hose. Keep in mind this high-quality product is made of durable metal and is sold individually. Please make sure to check the appropriate diagrams for your model for the correct location and application of this hardware.

This is an original manufacturer approved replacement item commonly used on trimmers, brushcutters and edgers. The purpose of this nut is to secure cutter head assembly to the spindle/shaft of a trimmer. It is a metal nut which is sold individually. Please only use properly sized wrench when securing or removing this nut.

The Blade Fixture is a silver, metal, individualy sold blade, which attaches at the bottom of the cutting head assembly, being held on by the nut and cotter pin. It is used to secure the blade fixing plate of the trimming tool. Installation is rated as "Easy" and requires a wrench and pliers to complete. If broken or damaged due to genera...Read morel wear, the cutting blade will not be secured, may be loose, or may not be able to stay on, which means you need to replace it. Refer to your make, model, and diagrams to ensure this is the correct part.