8035MG Pflueger Spinning Reels - Overview

The worm shaft goes next to the worm shaft bushing. It is made of metal and is sold individually. This is an authentic Shakespeare and Pflueger replacement part that is sourced from the original manufacturer for use with reels. A screwdriver might be required during the replacement of this part. It will require replacing if it breaks.

This is a genuine OEM sourced replacement gear designed for use with reels. This is an important part of the reel mechanism. It is made out of metal and it is sold individually. Replacing this gear you would need a screwdriver to remove the side plate.

It is a genuine item that is supplied by the original manufacturer for Shakespeare and Pflueger fishing reels. The one way clutch is an important mechanism that helps to engage the spool. Over time components may wear out or get damaged, causing the clutch to begin to fail and eventually requiring a replacement. Note, this high-quality it...Read moreem is sold individually. A screwdriver will be needed to take apart and reassemble the reel when performing this repair.

This item has been OEM sourced to ensure a high-level of quality. The metal bail spring is intended to be used with spinning reels from Shakespear and Pflueger. The bail spring fits within the rotor cover and is used to return the trip plunger to snap the bail wire back over the rotor. This item is available as an individual replacement part.

This bail arm guide is sourced from the original manufacturer for spinning reels. It is a small plastic piece located near the bail arm. The bail arm guide ensures that the line is accurately placed onto the spool during retrieval. It helps to keep the line from getting tangled or getting caught between the spool and the body of the reel...Read more. The bail arm guide should be replaced if it is damaged or worn down, as a faulty bail arm guide will cause the line to tangle or break during use. You will need to remove the rotor cover to access the bail arm guide. Locate and remove the screws that secure the arm guide in place. Gently pull off the faulty bail arm guide and place the new bail arm guide in the same position. Secure the new part using the appropriate fasteners and ensure that it is aligned correctly.