8008 (Type 1) Black and Decker Lawn Mower - Overview

This is a genuine Black and Decker replacement part, it is sold individually. It is made of plastic. The purpose of the 241381-01 Blade Insulator is to keep the 092715-00 spacer from coming in contact with the blade and to eliminate vibration.

Dewalt genuine replacement part, that is sold individually. 2 are needed for the tools listed below. It is always best to replace both brushes, even if only one is worn. Worn brushes frequently are the cause behind a motor running poorly. Replacing brushes can fix a motor that's operating intermittently. New brushes can restore a mot...Read moreor's electric braking. Carbon brushes are one of the most commonly replaced power tool parts. This is because carbon brushes are wear items, meaning that through friction and use they will gradually wear away until they need replacing. Worn brushes are a common causes of intermittent motor function, reduced electric braking and reduced motor power. A worn-out brush will often be worn down near to the wire lead and can be cracked, pitted, or burned. When replacing carbon brushes, be sure to inspect your armature for burns, cracks, or other damage which can indicate larger motor problems.

Genuine Black and Decker replacement part, this item is sold individually. This part is placed underneath the Hex Nut that holds the blade to the shaft on the mowers shown below. It helps secure the blade to the shaft assembly on the mower.

This is a Genuine Manufacturer Approved replacement Spacer for a Blade used on certain Black and Decker Lawn Mowers. It is made out of Metal and is Sold Individually. This Spacer sits on top of the Fan and it allows it to spin freely and with less friction.

This is a Manufacturer Approved replacement nut for Lawn and Garden equipment. This item is Metal an is Sold Individually. A lock nut is a type of nut that resists loosening when properly threaded onto a bolt. The purpose of this Nut is to secure the Cutting Blade to the Mowers Spindle/Shaft. You would need a Wrench to tighten or loosen this Hex Nut.

This brush insert is an OEM direct from DeWALT. The metal, brush insert is compatible with many mulch mowers. Secured onto the brush spring and terminal, this part has been designed to move electricity to the motor's armature. This part is sold individually. A screwdriver is helpful in the removal and repair.

This rectifier is an original part from Black and Decker. Composed of metal and plastic parts, the rectifier is compatible with a variety of tools and machines. This component the electric current fro AC to DC voltage. It is encouraged to refer to the specific manual and diagrams for repair instructions. This part is sold individually. A screwdriver is often helpful in making the replacement.

This authentic item is supplied directly from the original equipment manufacturer for use with DeWALT and Black and Decker lawn mowers. The purpose of a terminal is to allow a user to easily connect a wire. It provides an identical replacement for a missing or a faulty terminal that was installed on a new unit. Please make sure to check t...Read morehe appropriate diagrams of your model for the correct location and application of this hardware. Keep in mind this high-quality part is made of durable metal and is sold individually.

This is an authentic Black and Decker replacement part that has been sourced from the original manufacturer to be used with electric lawnmowers. The metal spring is used with the brush holder assembly and fits into the end cap to keep the carbon brushes pressed against the motor's armature. This item is priced as a single item, please note two may be required.

Drip bowls are located under the heating elements and catch grease and spills that come from cooking on your stove top. If your drip bowl is damaged or rusted, it could allow grease to drip inside your range. This 8 inch chrome drip bowl fits most electric ranges. Before you replace your damaged drip bowl, make sure the element is turned ...Read moreoff and cool to the touch. Installation is easy, just remove the element, replace the current drip bowl, and reattach the element. Make sure the small hole on the bowl lines up with the element socket. Drip bowls are sold separately.