EasyApplianceParts is now PartSelect! We've merged our sites to provide a better shopping experience for you.   Full Details
✖

Find Parts

Parts Departments

Top Model Types

Top Brands

Repair Help

Expert Repair Videos

Keep typing for more specific results...

79572032111 Kenmore Refrigerator - Overview

Enter a part description. DIY Heroes keep it simple, eg. "belt" or "pump".

Search filter:
Clear Filter
Your search term must have 3 or more characters.
Refrigerator Door Switch – Part Number: 6600JB1010A
$24.67
In Stock
Refrigerator Door Switch
★★★★★
★★★★★
(98)
Part #6600JB1010A
The interior light in your refrigerator is controlled by a switch that is activated when the door is opened and closed. If your refrigerator light will not turn on, or stays on when the door is closed, you could have a faulty switch. The switch is spring-loaded and is a generally closed type of switch meaning there should be no continuity when the button is pushed, and continuity through the switch when it is no longer engaged. This plastic, white, OEM switch is sourced directly from the manufacturer, is sold individually and is easy to replace. The repair usually takes less than 15 minutes and requires a flat-blade screwdriver and needle-nose pliers.
Refrigerator Water Filter LT700P – Part Number: AGF80300702
$72.73
In Stock
Refrigerator Water Filter LT700P
★★★★★
★★★★★
(22)
Part #AGF80300702
This refrigerator water filter replacement is for 2010 LG refrigerators that have either forward French doors or are the four-door dispensing models. This filter is designed to minimize impurities that can cause ill-tasting water or an unpleasant smell. It reduces sediment, dirt, rust, limescale, sand, and many other contaminants that can be harmful to your health and the life of your appliance. This filter should be replaced every 6 months or 200 gallons to ensure top quality performance. To remove your unwanted filter, press the push button to open the filter cover (water may spill from the hole), pull out the old cartridge in a downward motion. To install the new filter, make it so the ears are in the horizontal position and push the new cartridge into the housing until it stops. Push the filter upward until it is secure. Click the cover to lock it in place. Run water for approximately 5 minutes to prep the filter for use, and discard water. Reset the “filter reset” button if applicable.
Mullion Spring – Part Number: MHY62044103
$15.00
On Order
Mullion Spring
★★★★★
★★★★★
(50)
Part #MHY62044103
This spring is located on the mullion, or door flap, of your fridge. This spring is sourced from the genuine OEM manufacturer for various refrigerator models. It measures about 1.5 inches in total length, and is made entirely out of metal.
Plastic Tube - 5/16 Inch – Part Number: MJU62070602
$18.22
In Stock
Plastic Tube - 5/16 Inch
★★★★★
★★★★★
(24)
Part #MJU62070602
This water tube, or plastic tube, is used in refrigerators and freezers. The tube ensures water is directed to parts of the refrigerator that need it, such as the water dispenser and ice maker. If you find that your current one is leaking or broken in any way, replacing the tube can fix this problem. Make sure to unplug the appliance from the power source before you start this installation project. Refer to the diagram provided by the manufacturer for further instruction and accurate guidance.
Handle Screw – Part Number: MJB63190001
$15.00
In Stock
Handle Screw
★★★★★
★★★★★
(8)
Part #MJB63190001
This handle screw, also known as a mounting bolt, is a mounting screw to help secure the door handle to your refrigerator door. If your handle is loose, you may just need to tighten the screw. If your screw is missing or broken, it may need to be replaced. There are multiple handle screws on your fridge, please consider ordering extra as they commonly wear at the same rate. This is about 1 inch long and metallic in color.
Deli Drawer – Part Number: AJP73874601
$77.22
Special Order
Deli Drawer
★★★★★
★★★★★
(21)
Part #AJP73874601
This deli drawer is for refrigerators. Deli drawer holds meats, vegetables and snacks in the fresh food compartment of the refrigerator. Follow the instructions in the owner's manual when installing this part.
Water Inlet Valve Assembly – Part Number: AJU72992601
$122.57
In Stock
Water Inlet Valve Assembly
★★★★★
★★★★★
(16)
Part #AJU72992601
This includes the primary and secondary valves along with the wire harness.
Door Shelf Bin – Part Number: AAP73871501
$44.23
In Stock
Door Shelf Bin
★★★★★
★★★★★
(7)
Part #AAP73871501
Sold individually.
Freezer Handle Support – Part Number: DA61-08247A
$42.06
On Order
Freezer Handle Support
★★★★★
★★★★★
(10)
Part #DA61-08247A
This freezer handle support is a 2.5-inch by 1-inch white plastic bracket designed to provide support and stability to the right side of the freezer door handle. It is an authentic manufacturer replacement part that distributes the force placed on the handle during use to prevent excessive stress on one area of the handle. The handle support also secures the handle to the freezer door. You can find it on the inner right side of the freezer door handle. Over time the screw that secures the handle support may wear down or become stripped, or the plastic bracket may crack, causing the handle support to become unstable and unable to support the door handle. To access the faulty handle support bracket, first unthread the screws that secure it to the freezer door handle. Detach the handle and remove the screws that secure the handle support to the freezer door. Align the new handle support with the attachment points on the freezer door and secure it with the appropriate screws. Attach the handle to the new support and ensure it is securely fastened. Be careful not to not to overtighten the screws, to avoid stripping the mounting holes and damaging the handle support. Screws are sold separately. Please note that this support is for the right side of the handle. The left-side support is sold separately.
Door Holder – Part Number: MEG61899901
$23.60
In Stock
Door Holder
★★★★★
★★★★★
(5)
Part #MEG61899901
This is a manufacturer-approved refrigerator door closure for your refrigerator. It is made of white plastic and measures approximately 3 inches by 2 inches. If your old closure is damaged, your refrigerator door may not open and shut properly, and therefore it should be replaced.
Freezer Door Gasket – Part Number: MDS38201426
$80.82
In Stock
Freezer Door Gasket
★★★★★
★★★★★
(5)
Part #MDS38201426
Frost near the door or a freezer that runs often may have a damaged door seal. The flexible gasket blocks room air and moisture from entering the cold compartment. First clean the seal and contact surface, then check the hinges and door fit. Match the replacement to the complete freezer model and door position. If shipping leaves folds, soak the gasket in warm water for 5 to 10 minutes or use a hair dryer on low. Do not overheat the rubber. Smooth each side, close the door, and test the seal with a strip of paper.
Left Side Connector Rail – Part Number: 4932JA1010A
$23.60
In Stock

Questions And Answers for 79572032111

Ask our experts a question about this model and we'll get back to you as soon as possible!

Sort by:
  • 1
Sorry, we couldn't find any existing answers that matched.Try using some different or simpler keywords, or submit your new question by using the "Ask a Question" button above!
Cesar - For model number 79572032111
September 21, 2022
freezer compartment not freezing
Chris Boyle Profile
Hello Cesar, thank you for your question. Dirty condenser coils can considerably reduce freezer performance, they should be clean and dust free. Secondly, check the evaporator fan motor (part number: PS3523323) and make sure the evaporator fan is good. Next is to check the defrost sensor (part number: PS3636324), it is the part that prevents the freezer from getting too warm and controls the function of defrosting. A defective defrost heater (part number: PS3527753) can cause over-melting and prevent the freezer from freezing. Next, you need to check the condenser fan (part number: PS3523330), if it is not working the condenser will not be able to freeze in the freezer. We look forward to hearing from you if you need assistance with placing an order through our 7-days-a-week customer service. We hope this helps!
$109.40
In Stock
Evaporator Fan Motor
$119.53
On Order
Condenser Fan Motor
$109.40
Special Order
Sheath Heater
$45.29
In Stock
Defrost Sensor Assembly
Was this helpful?
Thank you for voting!
Nancy - For model number 79572032111
November 2, 2025
My Kenmore Model 795.72032111 refrigerator runs constantly. Both the refrigerator and freezer are not cold
Chris Boyle Profile
Hi Nancy, thank you for contacting us. The issue seems to be with the sealed system, like the compressor, part number PS12739218. You may need to replace it to fix the issue. We hope this sorts out your problem!
$492.75
Special Order
Compressor
Was this helpful?
Thank you for voting!
  • 1

Common Symptoms of the 79572032111

How this model fails, and the parts that fix it.

Watch our pros, then fix it yourself.

See how others fixed this model. Time, tools, difficulty, and steps that lead to victory! View More

Search repair tips from other customers using simple keywords like "replace", "fit", "remove", "inspect". DIY doesn't mean you have to do it alone!

Search filter:
Clear Filter
Your search term must have 3 or more characters.
replace leaking water inlet valve assembly
42 of 75 people found this instruction helpful.
  • Richard from JACKSONVILLE, FL
  • Really Easy
  • 15 - 30 mins
  • Screw drivers
1. Shut off water to refrigerator. 2. Removed bottom sheet metal cover (6 screws). 3. Removed leaking water inlet valve assembly from refrigerator (1 screw). 4. Remove water inlet tube (loosen nut) and tube back to refrigerator (pull from water valve after remove cotter pin washer). 5. Detach two electrical wire harnesses. 6. Install new water inlet valve assembly to refrigerator (1 screw). 7. Replace both water tubes to water inlet assembly. 8. Re-attach both wiring harnesses. 9. Turn water to refrigerator on. 10. Check for leaks. 11. Re-attach bottom sheet cover (6 screws).
Was this helpful?
Thank you for voting!
Remove and replace light switch
45 of 90 people found this instruction helpful.
  • Debbie from Waltham, MA
  • A Bit Difficult
  • 30 - 60 mins
  • Pliers, Screw drivers
Video makes it look easy. Kenmore refrigerator does not have "groove" along the right hand side of switch that allows for pushing down on release. Used a thin screwdriver to get under to push while holding switch edge with pliers. Kept slipping. Tape sides to avoid scratching inside of refrigerator.
Was this helpful?
Thank you for voting!
Very bad noise which stopped when the door was opened
15 of 20 people found this instruction helpful.
  • Rick from CLEVELAND, TN
  • Easy
  • 30 - 60 mins
  • Screw drivers
The Refrigerator now runs very quite.
After watching several videos I started on mine and found that it was a bit different than any in the videos. However all but the back panel was shown and that was helpful.
The back panel was a bit difficult but a hair dryer seemed to help .
All in all it was a good choice to do it myse lf as it was done quicker than waiting on a repair man.
Was this helpful?
Thank you for voting!