EasyApplianceParts is now PartSelect! We've merged our sites to provide a better shopping experience for you.   Full Details
✖

Find Parts

Parts Departments

Top Model Types

Top Brands

Repair Help

Expert Repair Videos

Keep typing for more specific results...

79570332410 Kenmore Refrigerator - Overview

Enter a part description. DIY Heroes keep it simple, eg. "belt" or "pump".

Search filter:
Clear Filter
Your search term must have 3 or more characters.
Refrigerator Door Switch – Part Number: 6600JB1010A
$24.67
In Stock
Refrigerator Door Switch
★★★★★
★★★★★
(98)
Part #6600JB1010A
The interior light in your refrigerator is controlled by a switch that is activated when the door is opened and closed. If your refrigerator light will not turn on, or stays on when the door is closed, you could have a faulty switch. The switch is spring-loaded and is a generally closed type of switch meaning there should be no continuity when the button is pushed, and continuity through the switch when it is no longer engaged. This plastic, white, OEM switch is sourced directly from the manufacturer, is sold individually and is easy to replace. The repair usually takes less than 15 minutes and requires a flat-blade screwdriver and needle-nose pliers.
Refrigerator Water Filter LT700P – Part Number: AGF80300702
$72.73
In Stock
Refrigerator Water Filter LT700P
★★★★★
★★★★★
(22)
Part #AGF80300702
This refrigerator water filter replacement is for 2010 LG refrigerators that have either forward French doors or are the four-door dispensing models. This filter is designed to minimize impurities that can cause ill-tasting water or an unpleasant smell. It reduces sediment, dirt, rust, limescale, sand, and many other contaminants that can be harmful to your health and the life of your appliance. This filter should be replaced every 6 months or 200 gallons to ensure top quality performance. To remove your unwanted filter, press the push button to open the filter cover (water may spill from the hole), pull out the old cartridge in a downward motion. To install the new filter, make it so the ears are in the horizontal position and push the new cartridge into the housing until it stops. Push the filter upward until it is secure. Click the cover to lock it in place. Run water for approximately 5 minutes to prep the filter for use, and discard water. Reset the “filter reset” button if applicable.
Handle Screw – Part Number: MJB63190001
$15.00
In Stock
Handle Screw
★★★★★
★★★★★
(8)
Part #MJB63190001
This handle screw, also known as a mounting bolt, is a mounting screw to help secure the door handle to your refrigerator door. If your handle is loose, you may just need to tighten the screw. If your screw is missing or broken, it may need to be replaced. There are multiple handle screws on your fridge, please consider ordering extra as they commonly wear at the same rate. This is about 1 inch long and metallic in color.
Roller Assembly – Part Number: AHJ72909001
$23.60
In Stock
Roller Assembly
★★★★★
★★★★★
(11)
Part #AHJ72909001
This is a drawer roller for the freezer compartment of your LG refrigerator. This roller is made of white plastic, and acts as a wheel to allow the drawer to glide smoothly back and forth when you open and close the freezer compartment. Over time and with further frequent use, this roller can crack, break, or stop rolling smoothly, at which point it will need replacing. Your refrigerator comes with two rollers, and this roller is sold individually, so consider how many rollers you require before ordering.
Deli Drawer – Part Number: AJP73874601
$77.22
Special Order
Deli Drawer
★★★★★
★★★★★
(21)
Part #AJP73874601
This deli drawer is for refrigerators. Deli drawer holds meats, vegetables and snacks in the fresh food compartment of the refrigerator. Follow the instructions in the owner's manual when installing this part.
Water Inlet Valve Assembly – Part Number: AJU72992601
$122.57
In Stock
Water Inlet Valve Assembly
★★★★★
★★★★★
(16)
Part #AJU72992601
This includes the primary and secondary valves along with the wire harness.
Refrigerator Spring – Part Number: MHY62044106
$15.00
In Stock
Refrigerator Spring
★★★★★
★★★★★
(12)
Part #MHY62044106
This mullion spring is designed for French-door refrigerators to provide tension and stability to the door flap that seals the space between the two doors. Its clockwise winding ensures proper alignment and secure closure, helping maintain a tight seal and consistent internal temperatures. If the mullion is not closing correctly or you're noticing frost buildup near the dispenser, replacing the spring may restore proper function. Always unplug the appliance before installation.
Refrigerator Ice Maker Kit Assembly – Part Number: AEQ73110210
$194.94
In Stock
Refrigerator Ice Maker Kit Assembly
★★★★★
★★★★★
(34)
Part #AEQ73110210
This ice maker assembly kit is designed to restore reliable ice production in select LG refrigerators by replacing worn or malfunctioning components. The kit includes essential parts such as the ice mold and ejection controls, which work together to manage water intake, freezing, and automatic dispensing of ice cubes. By maintaining consistent ice output, it supports everyday use and entertaining needs. Replacing a faulty ice maker can resolve issues such as failure to produce or dispense ice, as well as unusual operational noises. Installation involves removing the old assembly and securely fitting the new unit, ensuring proper alignment and connection to the refrigerator’s water and cooling systems. This repair enhances convenience and restores full functionality to your appliance.
Door Holder – Part Number: MEG61899901
$23.60
On Order
Door Holder
★★★★★
★★★★★
(5)
Part #MEG61899901
This is a manufacturer-approved refrigerator door closure for your refrigerator. It is made of white plastic and measures approximately 3 inches by 2 inches. If your old closure is damaged, your refrigerator door may not open and shut properly, and therefore it should be replaced.
Freezer Door Gasket – Part Number: MDS38201426
$80.82
In Stock
Freezer Door Gasket
★★★★★
★★★★★
(5)
Part #MDS38201426
Frost near the door or a freezer that runs often may have a damaged door seal. The flexible gasket blocks room air and moisture from entering the cold compartment. First clean the seal and contact surface, then check the hinges and door fit. Match the replacement to the complete freezer model and door position. If shipping leaves folds, soak the gasket in warm water for 5 to 10 minutes or use a hair dryer on low. Do not overheat the rubber. Smooth each side, close the door, and test the seal with a strip of paper.
Evaporator Fan Motor – Part Number: 4681JB1027C
$109.40
In Stock
Evaporator Fan Motor
★★★★★
★★★★★
(8)
Part #4681JB1027C
This is a genuine OEM evaporator motor that directly powers the evaporator mechanism within your refrigerator. This mechanism is responsible for pulling air over the evaporator coils, which are cold, and circulating that cold air back throughout the appliance. Without this motor, the interior of your refrigerator would build up frost, strain the compressor, and simply not cool your fridge enough. A warm fridge, frost buildup or unusual noises are all signs that this fan needs replacing, and over time or through excessive dust building up, motor issues will arise and can cause it to fail. This fan motor is sold as an individual part, so it does not come with any securing screws or the fan blade itself. Replacing the evaporator fan motor will require your user manual and Philips-head and flathead screwdrivers. You need to gain access to the evaporator cover, which you will need to locate using your user manual schematics. Once the cover is removed and you disconnect the wire harnesses within it, you can disassemble the fan mechanism on its inside portion. With the fan mechanism disassembled, remove the old mechanism and install the new one, with the securing screws and wire harnesses.
Refrigerator Lever Spring – Part Number: 4970JA3011K
$15.00
In Stock

Questions And Answers for 79570332410

Ask our experts a question about this model and we'll get back to you as soon as possible!

Sort by:
  • 1
Sorry, we couldn't find any existing answers that matched.Try using some different or simpler keywords, or submit your new question by using the "Ask a Question" button above!
Jim - For model number 79570332410
May 21, 2026
every once in a while week or two there is water that appears on the front edge of the frig. Looked under it's bone dry, just at the edge and runs out from there. Any ideas
Chris Boyle Profile
Hi Jim, thank you for your inquiry. The issue could be due to a clogged or partially frozen defrost drain. When the defrost drain backs up, meltwater pools inside the freezer compartment and slowly migrates forward, leaking out at the front threshold rather than going under the unit. Clear the defrost drain by pouring warm water down the drain hole inside the freezer floor. Also, inspect the freezer door gasket for any tears or areas that aren't sealing tightly. Glad to be of help!
No Longer Available
GASKET,DOOR
$94.13
In Stock
Door Gasket Assembly
$94.13
In Stock
GASKET ASSEMBLY, DOOR
Was this helpful?
Thank you for voting!
  • 1

Common Symptoms of the 79570332410

How this model fails, and the parts that fix it.

Watch our pros, then fix it yourself.

See how others fixed this model. Time, tools, difficulty, and steps that lead to victory! View More

Search repair tips from other customers using simple keywords like "replace", "fit", "remove", "inspect". DIY doesn't mean you have to do it alone!

Search filter:
Clear Filter
Your search term must have 3 or more characters.
replace leaking water inlet valve assembly
42 of 75 people found this instruction helpful.
  • Richard from JACKSONVILLE, FL
  • Really Easy
  • 15 - 30 mins
  • Screw drivers
1. Shut off water to refrigerator. 2. Removed bottom sheet metal cover (6 screws). 3. Removed leaking water inlet valve assembly from refrigerator (1 screw). 4. Remove water inlet tube (loosen nut) and tube back to refrigerator (pull from water valve after remove cotter pin washer). 5. Detach two electrical wire harnesses. 6. Install new water inlet valve assembly to refrigerator (1 screw). 7. Replace both water tubes to water inlet assembly. 8. Re-attach both wiring harnesses. 9. Turn water to refrigerator on. 10. Check for leaks. 11. Re-attach bottom sheet cover (6 screws).
Was this helpful?
Thank you for voting!
Remove and replace light switch
45 of 90 people found this instruction helpful.
  • Debbie from Waltham, MA
  • A Bit Difficult
  • 30 - 60 mins
  • Pliers, Screw drivers
Video makes it look easy. Kenmore refrigerator does not have "groove" along the right hand side of switch that allows for pushing down on release. Used a thin screwdriver to get under to push while holding switch edge with pliers. Kept slipping. Tape sides to avoid scratching inside of refrigerator.
Was this helpful?
Thank you for voting!
Broken glass shelf
9 of 9 people found this instruction helpful.
  • Pauline from CUTLER BAY, FL
  • Really Easy
  • 30 - 60 mins
I was unable to replace the shelf (no assembly required) because I was sent the incorrect part even though I gave the model #,
serial # and exact description and measurement to the agent to whom I spoke. Even worse, I was told that I was responsible for returning the part at my expense. Rather than risking getting another incorrec t part I will have a replacement plexiglass made to fit my shelf.
Was this helpful?
Thank you for voting!