Opening the refrigerator door releases this push-button switch to turn on the interior light, making stored food easier to see. When the door closes, it presses the button and turns the light off. A stuck, worn, or broken switch may leave the light off when the door is open or keep it on after closing. Replacing a faulty switch helps rest...Read moreore normal lighting control and reliable response to door movement. Disconnect the refrigerator from power before removing or installing the switch. This is an OEM part sourced directly from the manufacturer.
This plastic cover is a genuine OEM replacement part for your refrigerator. This part serves as the frame the glass shelf above your refrigerator crisper. To replace this part, remove the glass shelf and existing plastic frame. Snap the new one into place and replace the shelf. This repair has been rated as easy by our customers.
This part is a replacement light socket for your refrigerator. This model is white in color, and it has two sockets that will fit two separate light bulbs. The light socket connects to the power source, and the light bulb is screwed into it. If the light in your refrigerator is not working when you open the door, you could have a faulty s...Read moreocket. It is important to determine if the light bulbs are simply burned out, or if the socket is causing the issue. Be sure to disconnect your refrigerator from the power source before you begin this repair. This is an OEM part sourced directly from the manufacturer.
This part is a temperature sensing devise. It senses the rise in evaporator temperature during a defrost cycle and cycles the defrost heater off after all frost is melted. It is calibrated to permit a defrost cycle only when the temperature is below a preset temperature.
This door gasket assembly is a genuine OEM replacement part designed to create a secure, airtight seal around the refrigerator door. By preventing warm air from entering and cold air from escaping, it helps maintain consistent internal temperatures, supports energy efficiency, and preserves food freshness. The gasket is ideal for replacin...Read moreg worn, cracked, or damaged seals and is typically sold in its original packaging. Installation can be performed by the user, though folds or creases in the material may need to be smoothed out using warm water or a low-heat hairdryer. Always consult the appliance’s manual for proper installation guidance.
See how others fixed this model. Time, tools, difficulty, and steps that lead to victory!View More
Search repair tips from other customers using simple keywords like "replace", "fit", "remove", "inspect". DIY doesn't mean you have to do it alone!
Search filter:
Clear Filter
Your search term must have 3 or more characters.
Remove and replace light switch
45 of 91 peoplefound this instruction helpful.
Debbie from Waltham, MA
A Bit Difficult
30 - 60 mins
Pliers, Screw drivers
Video makes it look easy. Kenmore refrigerator does not have "groove" along the right hand side of switch that allows for pushing down on release. Used a thin screwdriver to get under to push while holding switch edge with pliers. Kept slipping. Tape sides to avoid scratching inside of refrigerator.
Was this helpful?
Thank you for voting!
Light stopped working
6 of 10 peoplefound this instruction helpful.
Tamara from MONDOVI, WI
Really Easy
Less than 15 mins
Screw drivers
Have had the Sears repairman come to the house to replace this part in 5 minutes for +$100.. twice. When my dad's stopped working, ordered the part and replaced it myself for the cost of the part and shipping. Use a screw driver to pry the right side of the switch and pull out. Best to watch a youtube video first. Takes about 5 minut
... Read morees.
Read less
Was this helpful?
Thank you for voting!
Bad Push Button Switch
7 of 13 peoplefound this instruction helpful.
Dorothy from KINGMAN, AZ
Really Easy
Less than 15 mins
Pliers, Screw drivers
I followed the directions! It was so easy that I bought another switch for my sister's fridge (same as mine). Her light was out too!