See how others fixed this model. Time, tools, difficulty, and steps that lead to victory!View More
Search repair tips from other customers using simple keywords like "replace", "fit", "remove", "inspect". DIY doesn't mean you have to do it alone!
Search filter:
Clear Filter
Your search term must have 3 or more characters.
Washer motor start windings burned up
37 of 48 peoplefound this instruction helpful.
Eric from Seabeck, WA
Really Easy
15 - 30 mins
Pliers, Screw drivers, Socket set
The motor was easy to replace: unplug the wiring harness, slip off the belts, release the tension springs from the motor carriage with needle-nose pliers, and then unbolt the motor carriage with socket set and remove from the washer. Remove the pulley from the old motor with allen wrench and transfer the carriage to the new motor. Revers
... Read moree operation for everything and you are back in business. The hardest part was the far back screw holding the carriage, a wobble extension helped.
Read less
Was this helpful?
Thank you for voting!
motor went out
15 of 39 peoplefound this instruction helpful.
jeff from shepherd, MI
Really Easy
15 - 30 mins
Screw drivers
simply removed old motor and replaced with new
Was this helpful?
Thank you for voting!
Washer would fill with water but not agitate, spin or drain.
Bob from Windsor, CA
Easy
30 - 60 mins
Screw drivers, Wrench set
Unplug the machine and disconnect the two water hoses. Use a short phillip screwdriver to remove two screws from the bottom front of the machine. Lift of the front panel to expose the motor. Lay the machine on its back on a 4 x 4 so the drain hose won't be damaged. If the screws appear rusted spary Kroil on them and let it soak for 45 - 6
... Read more0 mins. Remove the two belts. Remove the pulley via the set screw. Remove the four nuts to free the motor and slide plate. Undo all the wires. Remove the four nuts holding the slide plate. Install the new motor.